Loading ...
When choosing a location for your new heater, ensure that the general instructions are followed. Also, for best effect, install the
heater out of direct sunlight. Cold climate installation recommendation: when installing this unit against a non-insulated exterior
wall or chase, it is mandatory that the outer walls be insulated to conform to applicable insulation codes.
A 15 AMP, 120 Volt, 60 Hz circuit with a properly grounded outlet is required. Preferably, the heater will be on a dedicated circuit as
other appliances on the same circuit may cause the circuit breaker to trip or the fuse to blow when the heater is in operation. The
unit comes standard with 6 feet (1.8 m) three wire cord, exiting from the rear of the heater.
CAUTION: Do not exceed the current rating of the current tap. Always plug heaters directly into a wall outlet/receptacle.
NEVER use with an extension cord or relocatable power tap (outlet/ power strip).
Keep electrical cords, drapery, furniture and other combustibles at least 3 feet (0.6 m) from the front of the heater and away
from the sides.
WARNING: Make sure the power is turned off before proceeding. Any electrical repairs or rewiring of this unit should be carried
out by a licensed electrician in accordance with national and local codes.
If repairing or replacing any electrical component or wiring, the original wire routing, color coding and securing locations must
be followed.
WARNING: Electrical outlet wiring must comply with local building codes and other applicable regulations to reduce the risk
of fire, electrical shock and injury to persons.
WARNING: Do not use this heater if any part of it has been under water. Immediately call a qualified service technician to inspect
the heater and replace any part of the electrical system.
WARNING: Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electrical shock or
personal injury.
WARNING: During any service of this appliance, the power to the unit must be turned off. First turn the main power switch to
the “OFF” position. Then remove the electrical plug from the wall outlet.
HEATER LOCATIONIMPORTANT INSTRUCTION
ELECTRICAL CONNECTION
CLEARANCE TO COMBUSTIBLES
MAINTENANCE
Read all instructions before using this heater.
This heater is hot when in use. To avoid burns, do not let bare
skin touch hot surfaces. If provided, use handles when moving
this appliance. Keep combustible materials, such as furniture,
pillows, bedding, papers, clothes and curtains at least 3 feet
(0.9 m) from the front of the heater and keep them away from
the sides and rear. WARNING: In order to avoid overheating,
do not cover the heater. It cannot be used in a wardrobe.
CAUTION: Whenever the heater is left operating and
unattended, extreme caution is necessary if children or invalids
are nearby.
The appliance is not to be used by children or persons with
reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given
supervision or instruction.
Children being supervised not to play with the appliance.
Always unplug heater when not in use.
DO NOT operate any heater with a damaged cord or plug or
after the heater malfunctions, has been dropped or damaged
in any manner. Discard heater, or return to authorized service
facility for examination and/or repair.
If the supply cord is damaged, it must be replaced by the
manufacture, its service agent or similarly qualified persons in
order to avoid a hazard.
Any repairs to this heater should be carried out by a qualified
service person.
Under no circumstances should this heater be modified.
Parts having to be removed for servicing must be replaced
prior to operating this heater again.
DO NOT use outdoors.
This heater is not intended for use in bathrooms, laundry areas
and similar indoor locations. Never locate heater where it may
fall into a bathtub or other water container.
DO NOT run cord under carpeting. DO NOT cover cord with
throw rugs, runners or similar coverings. DO NOT route cord
under furniture or appliances. Arrange cord away from traffic
areas and where it will not be tripped over.
To disconnect heater, turn controls to the off, then remove
plug from outlet.
Connect to properly grounded outlets only.
This appliance, when installed, must be electrically grounded
in accordance with local codes or, in the absence of local
codes, with the current CSA C22.1 Canadian Electrical Code
or for U.S.A. installations, follow local codes and the National
Electrical Code, ANSI/NFPA NO.70. When using electrical
appliances, basic precautions should always be followed to
reduce the risk of fire, electrical shock, and injury to persons
including the following:
There is a thermostat limiter inside the heater. When the inner
temperature over heating or occurs abnormal heating, the
thermostat protective device would cut off power supply to
avoid the heater damaged or risk of fire.
DO NOT insert or allow foreign objects to enter any ventilation
or exhaust opening as this may cause an electric shock or fire,
or damage the heater.
To prevent a possible fire, do not block air intakes or exhaust in
any manner. DO NOT use on soft surfaces, like a bed, where
opening may become blocked.
A heater has hot and arcing or sparking parts inside. DO NOT
use it in areas where gasoline, paint or flammable liquids are
used or stored.
Use this heater only as described in the manual. Any other
use not recommended by the manufacturer may cause fire,
electric shock or injury to persons.
Always plug heaters directly into a wall outlet/receptacle.
NEVER use with an extension cord or relocatable power tap
(outlet/ power strip).
This heater is for use on 120 volts.
Loading ...
Loading ...
Loading ...