Loading ...
Loading ...
Loading ...
14
RANGE HOOD USE
The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after
the cooking is complete to clear all smoke and odors from the
kitchen.
The hood controls are located on the underside of the range
hood.
Range Hood Controls
Operating the light
1. Move the light switch to the “1” position to turn range hood
light to night light setting.
2. Move the light switch to the “2” position to turn range hood
light to full light setting.
3. Move the light switch to the “Off” position to turn range hood
light OFF.
IMPORTANT: Flicker and visual uctuation can be present every
time the lamp switch is activated. The duration of the icker will
depend on the manner and velocity that the light switch changes
position.
Operating the fan
1. Move the fan switch to the “On” position to turn the fan
ON. The fan will begin operating at the speed set on the fan
speed switch.
2. Move the fan switch to the “Off” position to turn the fan OFF.
Auto On Fan
The range hood is equipped with a sensor to automatically
turn on the fan when excessive heat is detected in the control
area. When the fan switch is in the “Off” position, this sensor
will turn the fan to high speed when necessary. When the heat
decreases, the fan will turn off.
When the fan switch is in the “On” position, the heat sensor is
not active and the range hood functions normally.
Adjusting the fan
The fan has 3 speed controls. Move the fan speed switch to “1”
position for low speed, “2” position for medium speed, or “3”
position for high speed.
Thermal Protector
The range hood is equipped with a thermal protector to avoid
overheating conditions. If the range hood shuts off while in use,
move fan slider switch to Off to turn off the range hood. Wait
approximately 60 minutes, then move slider to On to restart the
range hood.
RANGE HOOD CARE
Range Hood Lamps
Replacing a LED Lamp
Turn off the range hood and allow the LED lamp to cool. To avoid
damage or decreasing the life of the new bulb, do not touch bulb
with bare ngers. Replace bulb, using tissue or wearing cotton
gloves to handle bulb.
If new lamps do not operate, make sure the lamps are inserted
correctly before calling service.
1. Disconnect power.
2. Push up on the lens and turn it counterclockwise.
3. Remove the bulb and replace it with a 120V, 6.5W
maximum LED bulb with a GU10 base. Turn it clockwise to
lock it into place.
4. Repeat steps 2-3 for the other bulbs if needed.
5. Reconnect power.
A
B
C
A. Light control
B. Blower control
C. Fan speed control
Loading ...
Loading ...
Loading ...