Loading ...
Loading ...
Loading ...
12
EN
Removing the Bolt Assemblies
1
Starting with the bottom two transit bolts a, use
the spanner (included) to fully loosen all transit
bolts by turning them counterclockwise.
2
Remove the bolt assemblies by wiggling them
slightly while pulling them out.
3
Install the hole caps.
• Locate the hole caps b included in the
accessory pack or attached on the back.
Levelling the Appliance
Checking the Level
When pushing down the edges of the top plate
diagonally, the appliance should not move up and
down at all (check both directions). If the appliance
rocks when pushing the top plate of the appliance
diagonally, adjust the feet again.
NOTE
Timber or suspended type flooring may contribute
to excessive vibration and unbalance. Re
enforcement or bracing of the timber floor may need
to be considered to stop or reduce excessive noise
and vibration.
Do not install the washer on any elevated surface,
stand or plinth as it can become unstable and fall
causing serious injury and damage.
Adjusting and Levelling the Feet
When installing the appliance, the appliance should
be aligned and perfectly level. If the appliance is not
aligned and level properly, the appliance may be
damaged or may not operate properly.
1
Turn the levelling feet as required if the floor is
uneven.
• Do not insert pieces of wood etc. under the
feet.
• Make sure that all four feet should be stable
and resting on the floor.
2
Check if the appliance is perfectly level using a
spirit level a.
Loading ...
Loading ...
Loading ...