Loading ...
Loading ...
Loading ...
29-6273 11
Getting Started
Filter System
Your dishwasher has a
multiple Filter System.
In the System there
are three mesh filters.
It can separate soiled
water and clean water in
different chambers.
The multiple filter system
helps your dishwasher to
get better performance
with less water and less
energy.
USING THE DISHWASHER
Smart Wash System
Your dishwasher has a
Smart Wash System.
When a partial load of
lightly soiled dishes is
placed in the unit, a wash
cycle similar to a short
wash will automatically
be performed.
When a full load of heavily
soiled dishes is placed
in the unit, a heavy wash
cycle will automatically be
performed. It can determine
the type of cycle required
to clean the dishes and
will clean more efficiently
every time.
How your dishwasher cleans
Yourdishwashercleansbysprayingamixtureofhotwateranddetergentthroughthesprayarmsagainstsoiled
surfaces. The dishwasher fills with water covering the filter area. Water is then pumped through the multiple filter and
spray arms. Separated soil particles go down the drain as the water is pumped out and replaced with clean water.
The number of water fills will vary with the cycle being used.
Getting Started
1.Loadthedishwasher(SeeDish Preparation and Loading sections).
2. Add detergent (See Filling the detergent dispenser).
3. Add rinse aid (See Filling the rinse aid dispenser).
4. Close door.
5.PressthePower button,and then select desired Cycle (See Cycle Chart).
6. Select desired Options (See Control Panel). The indicator light above the pad will glow when selected.
7. Run the hot water faucet nearest the dishwasher until the water is hot, then turn it off.
8. To start, press Start/Cancel (See Control Panel).
Note: Your dishwasher has the controls mounted in the front of the door. The door should be closed first if
you want to operate the machine.
Wash Cycle Selections
Cycletimesareapproximateandwillvarywiththeoptionsselected.Hotwaterisnecessarytoactivatethedetergent
and melt fatty food soils. An automatic sensor will check the incoming water temperature. If it is not at the appropriate
temperature the timer will delay the cycle to allow automatic water heating during the main wash.
When the Hi-Temp wash is selected an even higher temperature will be assured to handle heavier soil loads.
Loading ...
Loading ...
Loading ...