Loading ...
Loading ...
Loading ...
6
7. Using the two #8-18 x 1/2" (13 mm) screws (provided),
fasten the retaining brackets to the countertop with the
mounting screws.
8. Grasp sides of compactor drawer and place the wheels of
the drawer into the tracks. Lift at the handle so drawer will
go over drawer stops. Close the drawer. Make sure the
drawer opens and closes freely.
If the toe guard rubs against oor, see “Adjusting the Toe
Guard” for further instructions.
Countertop Mounting
Countertop
Retaining
bracket
Mounting screw
(provided)
NOTE: If the retaining brackets cannot be attached to the
underside of the countertop, see the “Cabinet-face Mounting”
section.
Cabinet-face Mounting
(Use if countertop mounting is not possible.)
Mounting clip
(provided)
Cabinet face
Retaining
bracket
Mounting
screw
(provided)
Adjusting the Toe Guard
If the toe guard rubs the oor covering, the toe guard clearance
may be changed as follows:
1. Mark on each side of the toe guard the amount of toe guard
that rubs the oor covering.
2. Remove the drawer from the compactor. (See steps 8 and
9 in the “Unpacking” section.)
3. Use a ruler and a pencil or chalk to draw a line between the
marks on each side of toe guard. Use scissors or utility knife
to cut toe guard along line.
4. Replace drawer. If toe guard still rubs oor covering, repeat
steps 1-3.
Installing a Custom Panel
Dimensions
Custom panel thickness should be 1/2" (13 mm) to 5/8" (16 mm).
A panel thicker than 5/8" will interfere with the foot pedal
operation.
Dimensions shown are for the short panel.
15"
(381 mm)
2 x 1"
(25.4 mm)
23.8"
(605 mm)
A
A
CHAMFER 0.3"
(6.40 mm)
SECTION A-A
SCALE 2:1
2 X 0.13"
(3.20 mm)
Dimensions for
the short panel
with existing
handle
Dimensions shown are for the long panel. The long panel cannot
use the supplied handle.
15"
(381 mm)
25"
(635 mm)
Dimensions for
the long panel
with no handle
Bottom of drawer
Loading ...
Loading ...
Loading ...