Loading ...
Loading ...
Loading ...
11
N
0
5101 STREAMING SACD PLAYER/DAC / QUICK START GUIDE
CONTROL
NOTE: Manual set up is not recommended but is
available for advanced users should the need arise.
For WiFi manual set up:
1. Select
WiFi
under the
Select Interface
menu.
2. Press Enter.
3. Use ▲▼ key to select
Manual Input
.
4. Enter the SSID using ▲▼
▲
and press Enter.
5. Using the ▲▼ buttons, review the menu options then
select which security protocol your wireless network is
using and press Enter.
6. If you picked an option other than NONE, it should prompt
you for a password. Use ▲▼
▲
and Enter to select the
characters and enter the full password.
7. Press Enter.
For Ethernet manual set up:
1. Use ▼ to select
DHCP Off
(Manual).
2. Press Enter.
3. Use Numeric Keys and
▲
to enter the
IP Address
.
Press Enter.
4. Use Numeric Keys and
▲
to enter the
Subnet Address
.
Press Enter.
5. Use Numeric Keys and
▲
to enter the
Gateway Address
.
Press Enter.
6. Use Numeric Keys and
▲
to enter the
DNS1 Address
.
Press Enter.
7. Use Numeric Keys and
▲
to enter the
DNS2 Address
.
Press Enter.
Network Standby
Thi
s item determines whether network features are available
when the N
0
5101 is in standby mode. Selecting
Active
will
maintain the network connection (required for IP control).
Selecting
Standby
will allow the network hardware to be
powered down in order to reduce power consumption. It is
recommend that this is set to
Active
for optimum control and
performance.
Network Audio
Allows the user to enable or disable the UPnP rendering
capability of the player. Setting this option to
OFF
will disable
network audio.
DMR Device Name
This is the name that will show up on your network when
searching for your device from the Mark Levinson 5Kontrol app
or other third party app.
Default Layer
Allows the selection of
SACD
or
CD
to be the default media
layer that is played back. Turning this to
CD
will disable
playback of the DSD layer of an SACD disc, and route the PCM
signal to the digital outputs.
Disc Auto Play
This controls whether an optical disc will play automatically
after it is inserted. When set to
ON
, optical discs will play
automatically.
When set to
OFF
, the user must press Play to start the disc.
Load Defaults
This allows the user to load the default settings and write
over all of the saved settings. There is a protective prompt
that allows the user to cancel. Press the ▲ to be prompted
OK
. Press Enter to execute the command. Press ▼ to go back
to cancel prompt. DO NOT interrupt power during loading
process.
Auto Standby
This allows user to specify the period of inactivity after which
the unit will automatically enter standby. The options are:
5 Minutes
,
10 Minutes
,
15 Minutes
,
20 Minutes
and
OFF
.
Loading ...
Loading ...
Loading ...