Loading ...
Loading ...
RAPID CHANGE WEIGHT SYSTEMS
RAPID CHANGE
WEIGHT SYSTEMS
www.mxselect.com
SELECT
3
If the MX Dumbbell Cradle does not have the Cradle Feet fitted, go to Step 5; otherwise, follow the “How to Select
desired training weight” instructions above, and set the dial to 10, remove the MX Dumbbell Handset from the Cradle
and put aside. Setting 10 is the HEAVIEST, so take care when lifting and placing the dumbbell. Turn the Cradle over
and, using a 4mm Allen Key remove the Cradle Feet bolts and Cradle Feet.
Lay the Stand Uprights on the floor (careful not to damage
the floor or stand coating) and place the Stand Rear Support
in position to line up the bolt pattern on both parts.
Ensure the MX SELECT decal faces outwards on both Stand
Uprights and that the Warning decal on the Stand Rear
Support will face up when assembled. Attach the Stand
Uprights to the Stand Rear Support using 4 Stand bolts with
washers – DO NOT fully tighten at this time.
Place Stand assembly on the floor as shown, checking to
make sure the Stand assembly sits evenly on the floor.
FULLY TIGHTEN STAND BOLTS.
STEP THREE - ASSEMBLE THE STAND
STEP FOUR
Using the
4mm Allen Key.
Attach Uprights
to Rear Support
with Stand Bolts
& Washers
Loosely attach one Cradle on top of a Stand Upright using 2 of the Cradle Countersunk Bolts making sure the Weight
Legend can be read from the front. Repeat with the other Cradle. Tighten all bolts making sure the Cradles stay
parallel.
STEP FIVE - ATTACHING THE CRADLES TO THE STAND
5
4
1 32
Using the 3mm Allen Key.
Attach Cradle with
Countersunk Cradle Bolts
FRONT
Weight
Legend
read from
the front
Loading ...