Loading ...
Loading ...
Loading ...
5
.
Removing and Replacing the Ice Storage Bin:
1. Pull the covering panel up from the bottom.
2. Lift the plastic shutoff arm so it clicks into the Off (up)
position.
3. Lift up the front of the storage bin and pull it out.
4. Replace the bin by pushing it in all the way or the dispenser
will not work.
5. To restart ice production, lower the plastic shutoff arm into
the On (down) position. Make sure that door is closed tightly.
Water Filtration System
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Water Filter Status Light (on some models)
The lter status light will help you know when to change your
water lter, this is located in the refrigerator control panel.
■ The light will turn on red. This tells you that it is almost time
to change the lter.
■ It is recommended that you replace the lter when the status
light changes to red or water ow to your water dispenser or
ice maker decreases noticeably.
NOTE: The lter should be replaced at least every six
months depending on your water quality and usage.
Resetting the Filter Status
■ The reset button is located on the control panel in the
refrigerator compartment. To reset the status light after
changing the lter, press the button TEMP SETTING within 3
seconds.
The status light will change from red to off when the system
is reset.
Changing the Water Filter
Style 1
1. Locate the water lter cover door in the base grille, and pull
open the lter door. The lter will be released and then be
ejected as the door is opened.
2. When the door is completely open, pull the lter straight out.
NOTE: There may be some water in the lter. Some spilling
may occur. Use a towel to wipe up any spills.
3. Take the new lter out of its packaging and remove the
covers from the O-rings. Be sure the O-rings are still in place
after the covers are removed.
4. With the arrow pointing to the left (toward the lter cover
door’s hinge), align the new lter with the lter housing and
slide it into place. The lter cover door will automatically
begin to close as the new lter is inserted.
5. Close the lter cover door completely in order to snap the
lter into place. You may need to press hard.
6. Flush the water system. See the “Water and Ice Dispensers”
section.
Style 2
1. Locate the water lter cover door in the base grille, and pull
open the lter door.
2. Twist the water lter and turn 90° counterclockwise to
unlock.
3. Pull the lter out of the housing.
4. Remove the water lter cap from the water lter.
A
A. Water lter cover door
A. Water lter cover door
A
Loading ...
Loading ...
Loading ...