Loading ...
Loading ...
Loading ...
31
SETTING THE TIMER
To use the automatic close for the gate system
the timer switch should be put in the “ON”
position.
Set timer 3 to 60
seconds.
1. Turn MASTER timer ON.
2. Turn Second Timer to
Maximum Counterclockwise
Setting.
3. Use Timer on Master Board
Only. (3 to 60 seconds)
Master Board Second Board
Master Board
Second Board
1. Turn BOTH timers OFF.
Single Operator
Master/Second Operators
with Timers ON
with Timers OFF
Operators need to be connected by M/S LINK. See Linking Master page 19.
Master/Second control boards are interchangeable.
M/S LINK
NOTE: If a secondary photoelectric sensor
device is NOT used when the timer is ON, the
gate WILL hit a vehicle obstructing the gate
path before reversing during the close cycle.
To use the push close command,
the timer should be
switched to the
“OFF” position.
Push button
once to open
gate, push
button again to
close gate.
NOTE: Push button once to open gate, push
button again to close gate.
2. Turn SECOND timer OFF.
Loading ...
Loading ...
Loading ...