Loading ...
Loading ...
Loading ...
21
CLASS I, II, III, IV
Socket
FACTORY INSTALLED DC2000™ CONNECTION
DC2000™ 12Vdc Radio Receiver (Not Provided)
The DC2000™ needs a separate 12Vdc radio receiver to give remote commands to the operator during a power failure.
+12Vdc
Jumper P2:
to Constant (C)
Jumper P3:
to 12 Volt
NOTE: Refer to page 29
and 30 for programming
radio receiver.
DC2000™ Startup
Plug in the 12 pin plug into the DC2000™ control unit. Make sure
the “System ON” and “Charge OK” LEDs are lit. If the “Battery Low”
led comes on, the battery needs to charge before it can be used.
Make sure “Gate Direction” setting on DC2000™ is set the same as
the OmniControl™ board setting. See Adjustments.
Adjust “Reverse Sensor” setting. See Adjusting Reverse Sensor(s).
Reset button and interlock wires, Do Not Remove.
Push and Hold to operate gate.
Gate automatically opens.
Turn the 110Vac power off then push and Hold to operate gate.
Turn the 110Vac power off then gate opens automatically.
110Vac Power Failure
110Vac Power On,
OmniControl™ Board Malfunction
Auto Mode
Manual Mode
NOTE: All devices wired to the DC2000™ MUST be dedicated to it alone. Normal operation will be controlled by separate devices wired
to the OmniControl™ board and surge suppressor.
Example: If the DC2000 is “automatically opening” the gate due to a power failure (auto mode), any manual command such as
“One-Button”, “Three Push Button”, “Key Switch”, “Photoelectric Sensor” or “Edge Sensor” will cancel the automatic mode of the
DC2000™. After such cancellation, the DC2000™ will continue to operate in “manual mode” until 110Vac power is restored.
Loading ...
Loading ...
Loading ...