Loading ...
Loading ...
Loading ...
22
PROBLEM POSSIBLE CAUSE SOLUTION
The coee is not hot. The cups were not preheated. Warm the cups by rinsing them with hot
water (Please note: you can use the hot water
function).
The infuser (A15) has cooled down be-
cause 2/3 minutes have elapsed since
the last coee was made.
Before making the coee, heat the infuser by
rinsing using the "Rinse" function (see section
“7.1 Rinsing”).
A low coee temperature is set.
Set a hotter coee temperature (see section “7.9
Set temperature”).
17. TROUBLESHOOTING
Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Customer Services.
REDUCE COFFEE AMOUNT Too much coee has been used.
Select a milder taste by pressing the
button (B6-g. 10) or reduce the quantity of
pre-ground coee.
FILL BEANS CONTAINER The coee beans have run out. Fill the beans container (A3 - g. 14).
The pre-ground coee funnel (A4) is clogged. Empty the funnel with the help of the brush
(C5) as described in section “11.8 Cleaning the
pre-ground coee funnel”.
INSERT INFUSER ASSEMBLY The infuser has not been replaced after clea-
ning (A15).
Insert the infuser as described in the section
“11.9 Cleaning the infuser”.
INSERT TANK The tank (A16) is not correctly in place. Insert the tank correctly and press as far as it
will go.
GENERAL ALARM The inside of the appliance is very dirty. Clean the inside of the appliance thoroughly,
as described in section “11. CLEANING”. If the
message is still displayed after cleaning, con-
tact a service centre.
EMPTY CIRCUIT
FILL CIRCUIT
HOT WATER
Press OK
The water circuit is empty Press OK (B3 - g. 7) to deliver water from the
spout (C6) until it ows out normally. If the
problem persists, make sure the water tank
(A16) is fully inserted.
REPLACE FILTER The water softener lter (C4) is exhausted.
Replace the lter or remove it as described in
section “14. WATER SOFTENER FILTER”.
SET DIAL TO CLEAN Milk has been delivered recently and the tubes
inside the milk container (D) must be cleaned.
Turn the froth adjustment dial (D1) to CLEAN
(g. 25).
INSERT WATER SPOUT The water spout (C6) is not inserted or is
inserted incorrectly
Insert the water spout as far as it will go.
INSERT MILK CONTAINER The milk container (D) is not inserted correctly. Insert the milk container (g. 23) as far as it
will go.
Loading ...