Loading ...
Loading ...
Loading ...
EN
20
10. CARE AND CLEANING
10.1 Care and Cleaning
To clean the parts made of steel use a microfib-
er cloth and the sponge provided in the kit with
the appliance. Always use the cloth and sponge
in the direction of the steel’s satin finish.
Every now and then, to polish the steel, wipe
with a slightly damp microfiber cloth.
Do not use the sponge on aluminium parts, such
as the handles and the profiles of the glass
shelves.
You should use special care to keep the ventila-
tion openings in the appliance or in the cabinet
that houses it free of obstructions.
Scrupulously follow the detailed direc-
tions that can be found in the provided kit
and never use abrasive or metallic prod-
ucts which could scratch and damage the
satin finishing on the appliance perma-
nently.
Before performing any sort of cleaning,
disconnect the appliance from the electri-
cal power supply.
Make sure you do not damage the refrig-
erant circuit in any way.
Warning
The use of chlorine-based detergents or
similar that contains it should be avoided
(bleach, hypochlorite, etc).
10.2 Condenser cleaning
A ventilation grille is located either at the top of
the appliance or at the bottom according to the
model type.
To clean it use a vacuum cleaner with a soft
brush attachment at maximum power, sweep-
ing it along the vent slits. In case of a significant
dust build up, the ventilation grille can be re-
moved to allow a more accurate cleaning of the
filter.
Every 6 months the display shows the message
“Check Cond”, clean the condenser and press for
5 seconds the Enter
button to reset.
Operate as follows:
> Switch off the appliance by pressing the Unit
button on the main control panel for approx 3
seconds.
> Wait approx 30 minutes, until the finned con-
denser cools down to room temperature.
> On models with ventilation at the base remove
the grille at the bottom (magnetically attached)
and take it off. On models with ventilation lift the
grille as shown in the picture.
> Thoroughly clean the grille and the foam fil-
ter, by means of a vacuum cleaner and the soft
brush attachment.
> Clean it thoroughly from any dust build up as
shown in the picture, taking care not to damage
it.
> Start up the appliance again, by pressing the
Unit button
on the main
Warning
The edges of the condenser are sharp,
therefore use adequate protection for the
hands and arms when cleaning the con-
denser.
10.3 Internal cleaning
Clean the internal and removable parts by wash-
ing them with a solution of lukewarm water, a
small amount of dishwashing detergent.
Rinse and dry right away.
Do not use mechanical devices or other methods
to speed up defrosting.
Warning
Do not use water on the electrical parts,
lights and control panel.
Warning
The use of chlorine-based detergents or
similar that contains it should be avoided
(bleach, hypochlorite, etc).
Loading ...
Loading ...
Loading ...