Loading ...
Loading ...
Loading ...
Cybex 750C/750R Cycle Owner’s Manual
33
Level the unit.
Conrm that the unit is on a level surface. If not, use a 9/16” open-end wrench to adjust the leveling
feet up or down. See Figure 9.
Figure 9
Leveling
Feet
Visually inspect the unit.
1. Carefully examine the unit to ensure that the assembly is correct and complete.
2. Proceed to Testing the Operation section.
CAUTION: Serious injury or damage to machine can occur. To avoid injury or damage the
following procedure must be followed. Be sure that all electrical requirements
are met as indicated in the specications at the front of the manual and at the
beginning of this chapter prior to proceeding.
Testing the Operation
Use the following instructions to test the full resistance of the unit.
1. Plug the optional power cord into a power outlet from a grounded circuit as described under
Electrical Requirements in this chapter. Coil up the remainder of the power cord and place it
out of the way.
Cybex recommends that the unit be unplugged when not in use.
2. Observe that the control panel will illuminate and be in the Dormant Mode when using the
optional power adapter.
If not using the optional power adapter, the display will not illuminate until step 4.
3. Hold the handrails to steady self while stepping into the pedals.
4. Begin pedaling.
5. Press the Quick Start key. The unit begins with a long tone.
Loading ...
Loading ...
Loading ...