Loading ...
Loading ...
Loading ...
Installation Instructions
MOVE DRYER AND STAND INTO
FINAL POSITION AND INSTALL
DRYER EXHAUST
Push the dryer and stand against the wall in
the selected location.
If the hole for the exhaust has been
located as shown in the Utilities and
Grounding illustration, it will align with the
dryer exhaust when the stack stand and
dryer are placed in the selected operating
position.
9
INSTALL WASHER
Follow the Installation Instructions
included with your washer to make washer
connections.
After washer connections are made,
move the washer into its operating position
between the stand side sections and push it
completely toward the rear. Use care not to
kink or pinch the water inlet hose, and be
sure the drain hose is placed in the drain
pipe with no kinks or twists.
Follow the Installation Instructions
included with your dryer to make exhaust
connections.
SECURE STAND TO WALL
After the exhaust is connected and the dryer
and stack stand are in the selected operating
position, secure the stand to the wall using 2
Type C screws in the holes started earlier.
10
INSTALL LID LATCH
If a washer with a lift lid is to be installed and
used under the stand, install the washer lid
latch as shown using a Type D screw in the
hole behind one of the front mounting holes.
The lid latch may be installed on either side.
NOTE: The screw for the lid latch will thread
into bottom of the dryer. Tighten securely
using a nut driver.
11
12
Dryer Mounting
Holes
Lid Latch
Mounting Hole
Lid Latch
Type D Screw
Spacer Ring
6
Loading ...
Loading ...
Loading ...