Loading ...
Loading ...
Loading ...
Installation Instructions
5
LOCATE MOUNTING HOLES
Push the dryer and stand against the wall
in the selected location and locate two wall
studs.
Start 2 Type C screws through holes in the
mounting bracket that line up with studs. DO
NOT SCREW IN ALL THE WAY. Multiple holes
in the bracket allow for variation in location
of wall studs.
7
INSTALL DRYER TO STAND
Carefully follow section entitled Preparing
Your Dryer for Installation in the Installation
Instructions for your new dryer. The dryer
weighs approximately 100 pounds.
WARNING
Potential Personal Injury. More than one
person is recommended to lift the dryer
into position because of its weight and size.
Failure to do so could result in personal
injury or death.
Use 6 Type D screws to secure the dryer to
the stand. Tighten the screws using an
adjustable wrench or nut driver. The dryer
will sit approximately 1
1
⁄4″ forward of the
end of the top angle.
8
NOTE: The outside holes are used for 22″
width, and the inside holes are used for 24″
width.
Once the holes are started, remove the screws
from the mounting bracket and move the
stand away from the wall.
For installations requiring clearance from
the wall:
If the stand cannot be pushed all the way
against the wall, secure a piece of wood to
the wall studs to line up with the holes on the
mounting bracket. The wood must be the
same thickness as the clearance. Follow the
steps above, starting the screws in the piece
of wood.
Loading ...
Loading ...
Loading ...