Loading ...
Installation Instructions
2
PARTS INCLUDED (cont.)
The stand base has an angle bracket at each
end. One end of the angle bracket is 22
1
⁄2″
long and has mounting holes in it. This end
goes up. The other end of the angle bracket
is 28″ long and has no holes. This longer end
(without holes) goes down.
DETERMINE STAND WIDTH
Your new stand can be assembled to two
different widths:
• 22″ for smaller, compact washers
• 24″ for larger washers
Check your washer width to determine the
stand width you need. The compact dryer
will assemble to either width.
1
ATTACH WALL MOUNTING
BRACKET
Attach one end of the wall mounting
bracket to one of the upper rear holes on
one of the stand bases using a Type A
screw and a lock nut. Make sure screws are
inserted from the top and the lock nuts are
on the bottom. Use the inside hole on the
stand base for 24″ width. Use the outside
hole for 22″ width.
2
Attach the other end of the bracket to the
upper rear hole of the other stand base the
same way. Use the inside hole on the stand
base for 24″ width or the outside hole for
22″ width. Hand-tighten the screws and
nuts.
Bracket
Type A Screw
Lock
Nut
Use outside
holes for
22″ models
Use inside
holes for
24″ models
Wall
Mounting
Bracket
Cross
Brace
Diagonal
Brace
Stand Bases
Loading ...
Loading ...
Loading ...