Loading ...
Loading ...
Loading ...
13 Useful Remote Control Features
62
En
Learning function of the remote control
unit
You can operate the connected AV products (AV Receiver, Cable
Box, SAT tuner, VCR, DVD, DVD recorder, LD) using the learning
function of your remote control unit. This remote control unit
has a function that can memorize each remote control code.
2 to 5 cm (0.8 to 2.0 inches)
Remote control Remote control of
(Supplied accessory) AV product
Using the learning function
1
Slide the Mode switch to match the device whose remote
control signal you want to be learned.
2
Press EDIT/LEARN and 2 at the same time.
•The LED flashes.
3
Press a button to be learned.
• The LED lights up.
•For the functions that can be learned, see pages 64 to
68.
• When learning is finished, the LED starts flashing
again.
4
Press EDIT/LEARN again to exit the Learn mode.
•To exit the Learn mode halfway, press EDIT/LEARN again.
• If the Mode switch selection is changed when in the Learn mode,
the Learn mode is cancelled.
• If no operation is performed for more than one minute, the Learn
mode is cancelled.
• It takes about 2 seconds to finish code transmission. Do not interrupt
it halfway. Wait until the LED flashes again.
•You can reset all learned codes to the factory defaults. When not in
the Learn mode, press and hold TV , and then press and
VOL + (RECEIVER section) at the same time.
Presetting manufacture codes
1
Slide the Mode switch to match the device to which you
want to preset the remote control signal.
2
Press EDIT/LEARN and 1 at the same time.
• The LED flashes.
3
Press 0 – 9 to enter the manufacture code. See page 63.
•Preset mode is finished once the LED no longer lights
up.
•To exit the Edit mode halfway, press EDIT/LEARN again.
• If the Mode switch selection is changed when in the Edit mode, the
Edit mode is cancelled.
• If no operation is performed for more than one minute, the Edit mode
is cancelled.
• When you enter a code not listed, the LED flashes quickly.
• If the table on page 63 does not include your desired manufacturer or
the remote control does not work, you can make the memory learn
its signal by the Learn mode.
• The initial mode is “000” (PIONEER).
13-PDP5045HD-Eng (62-68) 6/26/04, 11:5762
Loading ...
Loading ...
Loading ...