Loading ...
Loading ...
Loading ...
3 Philips · PPX3610
1 General Safety Information
Do not make any changes or settings that are not
described in this user manual. Physical injury or damage
to the device or loss of data can result from improper
handling. Take note of all warning and safety notes indi-
cated.
Setting up the Device
The unit is for indoor use only. The device should be
placed securely on a stable, flat surface. Position all
cables in such a way that no one will stumble on them,
thus avoiding possible injuries to persons or damage to
the device itself.
Do not plug in the device in moist rooms. Never touch
the main
s cable or the mains connection with wet
hands.
The device must have sufficient ve
ntilation and may not
be covered. Do not put your device in closed cabinets
or boxes.
Do not place the machine on soft surfaces such as table-
cloths or carpets and do not cover the ventilatio
n slits.
Otherwise the device could overheat or catch fire.
Protect the device against direct sunlight, heat, large
temperature fluctuat
ions and moisture. Do not place
the device in the vicinity of heaters or air conditioners.
Observe the information on temperature and humidity
in the technical data.
When the device is running for
a lo
ng period of time,
the surface becomes hot and a warning symbol appears
on the projection (see also Symbols in the Statusbar,
page 10). The device behaves as follows:
1 The fan turns to maximum level.
2 At maximum level of brightness the overheat symbol
appears in t
he status bar and the device turns auto-
matically to minimum level of brightness.
3 At minimal level of brightness the overheat sy
mbol
shows for three seconds in the middle of the screen.
Then the device turns off automatically.
After the device has cooled down, you can continue
playback.
Do not allow liquids to enter into the device. Switch off
the d
evice and disconnect it from the mains supply if liq-
uids or foreign substances end up inside the device.
Have the unit
inspected by a technical service depart-
ment.
Always handle the unit with care. Avoid touching the
lens. Never
place heavy or sharp objects on the projec-
tor or the power cable.
If the projector gets too hot or emits smoke, shut it
down immed
iat
ely and unplug the power cable. Arrange
for your device to be investigated by a technical service
centre. To prevent the spread of fire, open flames
should be kept away from the device.
Under the following conditions, a layer of moisture can
appear i
nside the device which can lead to malfunctions:
• if the device is moved from a cold to a warm
area;
• a
fter a cold room is heated;
• when this device is placed in a damp room.
Proceed as follows to avoid any moisture build-up:
1 Seal this device in a plastic bag
before moving it to
another room, in order for it to adapt to room con-
ditions.
2 Wait one to two
hours before
you take the device
out of the plastic bag.
The device should not be used in a very dusty environ-
ment. Dust particles and other foreign objects may
dam
age the unit.
Do not expose the device to extreme vibrations. It may
damage the internal components.
Do not allow children to handle the device without
supervision. The packing materials should be kept out of
the hands of children.
Repairs
Do not repair the device yourself. Improper mainte-
nance can result in injuries or damage to the device.
Your d
evice must be repaired by an authorised service
centre.
Find details of authorised service centres on the war-
ranty card.
Do not remove the type label from your device; this
would
void the warranty.
Loading ...
Loading ...
Loading ...