Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 65
Push the blue button on the faceplate
or touchscreen or press and slide the
temperature bar towards the blue
arrow button on the touchscreen for
cooler temperature settings.
NOTE:
If your vehicle is equipped with a Uconnect 5
radio, the temperature can be adjusted by
pressing the Temperature readout on the top
left and right corners of the status bar.
SYNC Button
Press the SYNC button on the
touchscreen to toggle the SYNC
feature on/off. The SYNC indicator is
illuminated when this feature is
enabled. SYNC is used to synchronize the front
and rear passenger temperature settings with
the driver temperature settings. Changing the
front or rear passenger temperature setting
while in SYNC will automatically exit this
feature.
NOTE:
The SYNC setting is only available on the touch-
screen.
Blower Control
Blower Control regulates the amount
of air forced through the climate
control system. There are seven
blower speeds available. Adjusting
the blower will cause automatic mode to switch
to manual operation. The speeds can be
selected using either the blower control knob on
the faceplate or the buttons on the
touchscreen.
Faceplate: The blower speed increases as
you turn the blower control knob clockwise
from the lowest blower setting. The blower
speed decreases as you turn the blower
control knob counterclockwise.
Touchscreen: Use the small blower icon to
reduce the blower setting and the large
blower icon to increase the blower setting.
Blower speed can also be selected by
pressing the blower bar area between the
icons.
Mode Control
The airflow distribution mode can be
adjusted so air comes from the
instrument panel outlets, floor
outlets, defrost outlets and
demist outlets.
Faceplate: Push the button in the center of
the knob to change the airflow distribution
mode.
Touchscreen: Select Mode by pressing one of
the Mode Buttons on the touchscreen.
Panel Mode
Air comes from the outlets in the
instrument panel. Each of these
outlets can be individually adjusted to
direct the flow of air. The air vanes of
the center outlets and outboard outlets can be
moved up and down or side to side to regulate
airflow direction. There is a shut off wheel
located below the air vanes to shut off or adjust
the amount of airflow from these outlets.
2
21_RUV_OM_EN_US_t.book Page 65
Loading ...
Loading ...
Loading ...