Loading ...
Loading ...
Loading ...
28 (GB)
The INSTALL SETTING
Menu
The INSTALL SETTING menu is used for changing
the settings of the projector.
KEYSTONE MEM
ON: DIGIT KEYSTONE setting is stored.
The data is retrieved when the projector power is
turned on. The setting will remain the same every
time.
OFF: DIGIT KEYSTONE is reset to 0 when the
power is turned on the next time.
DIGIT KEYSTONE
Corrects the trapezoid caused by the projection angle.
If the base edge is longer, set a negative value; if the
upper edge is longer, set a positive value to square the
image.
Note
If “ZOOM”, “FULL” or “NORMAL” have been
selected in the ASPECT of the INPUT SETTING, you
can change the trapezoid.
The INSTALL SETTING Menu
INSTALL SETTING
KEYSTONE MEM:
OFF
DIGIT KEYSTONE:
0
INSTALLATION:
FLOOR-FRONT
CINEMA BLACK:
ON
LAMP TIMER: 234h
INPUT-A
INSTALLATION
Sets to reverse the picture horizontally or vertically.
FLOOR-FRONT: The picture is not reversed.
CEILING-FRONT: The picture is reversed
horizontally and vertically.
FLOOR-REAR: The picture is reversed
horizontally.
CEILING-REAR: The picture is reversed
vertically.
Note
In case of using a mirror, be careful of installation
since the picture may be reversed.
CINEMA BLACK
Switches the lamp wattage during projection.
OFF: Normal wattage.
ON: Enhances the black by reducing the lamp
wattage.
Notes
•It will take a few seconds for the projector to change
the lamp wattage during projection.
•If the CINEMA BLACK is set to ON, it starts with
OFF when the power is turned on, then changes to
ON after a while.
LAMP TIMER
Indicates how long the lamp has been turned on.
Note
This only displays the time. You cannot alter the
display.
Loading ...
Loading ...
Loading ...