Loading ...
Loading ...
Loading ...
7. Push the flexible tube down onto the tank tube as far as it will
go. Position the hose clamp so that it is close to the end of
flexible tube.
8. Install saddle valve kit or other plumbing parts as needed to
connect 1/4" (6.4 mm) tubing from faucet easy-connect fitting
to cold water supply line.
9. Flush line into bucket or pan to remove any debris that may
have been trapped in supply line during plumbing connection.
10. Check that water flows freely and that there are no leaks.
11. Connect 1/4" water supply line tubing to faucet copper tubing
with the factory-assembled easy-connect fitting. Push water
supply line tubing straight into fitting as far as it will go. Pull
on tubing. The tubing should not come out when properly
installed.
NOTE: If you need to remove tubing, push down on collet and
pull tubing out of easy-connect fitting.
IMPORTANT: For proper operation, do not remove the
factory-assembled easy-connect fitting from tube.
12. Open water line to faucet.
Complete Installation
IMPORTANT: The hot water dispenser can be damaged if the
following steps are not followed.
NOTE: Do not plug power supply cord into outlet.
1. Turn Temperature Control counterclockwise to “Off” position.
2. Push down and turn the faucet cap clockwise to open faucet.
Hold cap open until water flows from the faucet (about 1 to
1-1/2 minutes).
3. Release faucet cap. Check for leaks.
6
factory assembled
easy-connect fitting
hose
clamp
On
NOTE: Make sure the Temperature Control is in the “Off” position
before plugging hot water dispenser into power supply. If tank is
empty and thermostat is in an “On” position when the power
supply cord is connected, the heater will overheat causing an
unpleasant taste, black specks in the water, and permanent
damage to the hot water dispenser.
4. Once water is flowing from faucet, the water heating tank has
been filled with water. Plug power supply cord into grounded
3 prong outlet.
5. Turn Temperature Control clockwise to highest position.
Water in tank will reach maximum temperature in about 15
minutes.
NOTES:
• When water is heating, you may hear gurgling noises
coming from the tank.
• There may also be a small amount of spitting or hot water
flow from the faucet. This is normal for the initial heat-up of
the dispenser.
• The Temperature Control controls tank heater, not water
delivery. Rotate Temperature Control clockwise to make
water hotter, counterclockwise to lower water temperature.
• Turn Temperature Control to lower temperature setting if you
notice vapor or hear boiling noise.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
Loading ...
Loading ...
Loading ...