Loading ...
Loading ...
Loading ...
5
5. Lay spout assembly on flat surface with coiled tubing facing
up. Using one hand to hold tubing just below spout, carefully
straighten tubing with other hand. Slide gasket over tubing so
that lip side of gasket is seated into base of spout.
6. Loosen square nut until it is flush with end of the mounting
screw. Tip spout bracket against mounting screw. (Bracket will
form a “y” when in the correct position.) Hold nut, bracket,
gasket and tubing in position and insert into hole in sink or
counter.
7. Pull up on spout body to keep tension on spout mounting
bracket and nut. Tighten screw inside the spout until spout is
securely in position. Do not overtighten.
8. Snap on On/Off Cap.
Installing the Tank
1. Position tank vertically beneath faucet so that the longer
copper tube from the faucet reaches the easy-connect fitting
on top of the tank.
2. Use a pencil to mark on the wall where the top of tank needs
to be located. Set tank aside. Mark a second line 2-1/4"
(5.7 cm) below the first line.
IMPORTANT: The tank must be positioned so that the copper
tubing and flexible tubing from the faucet does not kink.
3. Position mounting bracket on wall so that bottom of mounting
bracket is even with the lower line.
gasket
mounting screw
square nut
bracket
4. Use two screws (and plastic anchors if attaching to dry wall)
to fasten mounting bracket to wall. Hang tank on bracket.
IMPORTANT: Do not plug power supply cord into outlet at
this time.
5. IMPORTANT: Do not lengthen, twist or tightly bend tubing.
Do not use any sealing compounds.
Connect the longest 1/4" copper faucet tube to the rear easy-
connect fitting on top of tank. Push tubing straight into fitting
as far as it will go. Pull on tubing. The tubing should not come
out when properly installed.
NOTE: If you need to remove tubing, push down on collet.
Pull tubing out of easy-connect fitting. It is easier to push the
collet down if a 1/4" or 7 mm open-end wrench is used as
shown.
6. Connect the flexible tube from the faucet to the center tank
tube. Make sure the flexible tube does not kink. To avoid
kinking, the tube may be shortened.
The center tank tube is not an easy-connect fitting. To
connect the flexible tube, use pliers and open the supplied
hose clamp. Slide the clamp onto the flexible tube about 2"
(5 cm) from the tube end.
mounting
bracket
2-1/4"
(5.7 cm)
off position
easy-connect
fitting
collet
copper
faucet tube
copper
faucet tube
collet
1/4" or 7 mm
open-end
wrench
flexible
tube
hose
clamp
tank
tube
Loading ...
Loading ...
Loading ...