Loading ...
Loading ...
Loading ...
16
Care and Cleaning (cont.)
5. Slide the bowl support down so that
the tabs on the back of the bowl
support line up with the slots
in the column. Remove the bowl
support by passing the tabs
through the slots.
6. Clean the bowl support and column
with the mild detergent and a wash
cloth. Do not use abrasive cleansers
or scouring pads.
7. To reassemble, reverse steps
1 through 6.
1. Unplug the Stand Mixer or disconnect
the power.
2. Remove the retaining ring with
retaining ring pliers, slide the ring
and the washer down the shaft.
3. Clean the shaft, retaining ring, and
washer with a mild detergent and wash
cloth. Do not use abrasive cleaners or
scouring pads. Do not immerse the
stand mixer in water.
4. To reassemble, reverse steps 1 through 4,
making sure retaining ring is fully seated
into groove.
Flat Beater Cleaning Instructions
1. To clean the drain hole in the at
beater, use a small round brush,
toothpick, or skewer to run through
the hole.
Retaining Ring
Groove
Retaining Ring
Washer
Planetary Cleaning Instructions
W10581080B_FINAL.indd 16 4/5/13 10:53 AM
Loading ...
Loading ...
Loading ...