Loading ...
Loading ...
Loading ...
15
14
Programme)
(Standard
NOTE: A click could be heard when the door is closed perfectly.
When the washing is over, you can shut off the switch by pressing ON/OFF button.
NOTE:
main power and water supply before calling a service.
If all the lights begin to glimmer, that indicates the machine is out of order, please turn off the
Forget to Add Dish
A forgotten dish can be added any time before the detergent cup opens.
1 Open the door a little to stop the washing.
2 After the spray arms stop working, you can open the door completely.
3 Add forgotten dishes.
4 Close the door, the dishwasher will work after ten seconds.
WARNING!
It is dangerous to open the door when washing, because the hot water may scald you.
Switch Off the Dishwasher
The digital display appears "---" and the buzzer rings 6 times, only in this case the programme
has ended.
1.Switch off the dishwasher by pressing the ON/OFF button.
2.Turn off the water tap!
Open the door carefully. Hot steam may escape when the door is opened!
■Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around
15 minutes before removing from the appliance.
■Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In
this way they will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside.
Empty the lower basket first and then the upper one. This will avoid water dripping from the upper
basket onto the dishes in the lower one.
Change the Programme.
Premise: A cycle that is underway can only be modified if it has only been running for a short time.
Otherwise, the detergent may have already been released, and the appliance may have already
drained the wash water. If this is the case, the detergent dispenser must be refilled (see the section
entitled " Fill in the Detergent " ).
Open the door, Press current prog. button more than three seconds to cancel the programme, then
you can change the programme to the desired cycle setting (see the section entitled "Starting a wash
cycle. . . " ). Then, close the door.
NOTE: If you open the door when washing, the machine pauses and warning alarm rings, the display
appears E1. When you close the door, the machine will keep on working after 10 seconds.
The 6 programme lights show the state of the dishwasher:
a) All program lights off --> stand by
b) One of the program lights on --> cycle running
c) One of the program lights blinking --> pause
2. Insert the plug into the socket. The power supply is 220-240V AC 50 Hz, the specification of the
socket is 12 A 250 VAC.50 Hz.
Make sure that the water supply is turned on to full pressure. Open the door, press the ON/OFF
button, Press the "program." button to select a desired "Wash cycle". (See the section entitled "Wash
Cycle Table") . With a little force to ensure the door is properly closed.
6. Starting a Washing Programme
Starting a wash cycle...
Draw out the lower and upper basket, load the dishes and
1. push them back. It is recommended to load the lower basket first, then the upper one (see the
section entitled "Loading the Dishwasher"). Pour in the detergent (see the section entitled "Salt,
Detergent and Rinse Aid").
2. Insert the plug into the socket. The power supply is 220-240V AC 50 Hz, the specification of the
socket is 12 A 250 VAC.50 Hz.
Make sure that the water supply is turned on to full pressure. Close the door, press the "Power"
button, press the "program". button to select a desired "Wash cycle". (See the section entitled "Wash
Turning on the Appliance
60436:this program is the test cycle.
EN
The information for comparability test in accordance with EN 60436,as follows:
-
-
Position of upper basket :Low position
Capacity:14 settings
-
Rinse aid setting:6(or 4 for four setting dispenser)
Wash cycle table
60 min
For lightly and normally soiled
plates and pans for everyday
Hot rinse 1
Hot rinse 2
Hot rinse(60℃)
Drying
Program
Cycle Selection
Information
Description
of Cycle
Detergent
Pre/main
Running
Time(min)
Energy
(kWh)
Water
(L)
Intensive
Light
Crystal
Rapid
Pre-Rinse
For the heaviest soiled loads,
such as pots, pans, casserole
dishes and dishes that have
been sitting with dried food
on them for a while.
For normally soiled loads,
such as pots, plates, glasses
and lightly soiled pans.
standard daily cycle.
For lightly soiled loads, such
as plates, glasses, bowls and
lightly soiled pans.
Crystal wash cycle to be used
for more delicate items which
are sensitive to high
temperatures.
immediately after
A shorter wash for lightly
soiled loads that do not
need drying.
To rinse dishes that you
plan to wash later that day
Pre-wash
Main wash(60℃)
Rinse1
Rinse2
Hot rinse
Drying
Pre-wash
Main wash(46℃)
Hot rinse
Drying
Pre-wash
Main wash(45℃)
Rinse
Hot rinse
Drying
Rinse
Hot rinse
Drying
Main wash(40℃)
Main wash(40℃)
Hot rinse
Pre-wash
4/18
4/18
3/16
3/16
3/16
15
213
239
152
124
40
12
18
10
14
11
7
4
1.50
0.84
0.95
0.90
0.55
0.01
60 1.00 11.5
(*E 60436)
/
N
(Or 3in1)
(Or 3in1)
(Or 3in1)
(Run cycle
use)
0
8
3.Washing tableware in a household dishwasher usually consumes less energy and water than
hand dishwashing when the household dishwasher is used according to this instruction manual.
2.Manual pre-rinsing of tableware items leads to increased water and energy consumption and is
not recommended .
1.The ECO program is suitable to clean normally soiled tableware,it is the most efficent program
in terms of its combined energy and water consumption .
Loading ...
Loading ...
Loading ...