Loading ...
Loading ...
Loading ...
63
USING THE EXTRACTOR FAN
Power-on
Press (touch) ON/OFF hob/ extractor
The indicator light will turn on to indicate that the hob/extractor
is ready for use
Press again to turn off
Note: This function has priority over the others.
Switching on the extractor fan:
Touch (press) the Selection bar (6) to activate the extractor
fan
Extraction speed (power):
Touch and scroll along the Selection bar (6):
to the right to increase the speed (power) of the extractor fan
(0-10);
to the left to decrease the speed (power) of the extractor fan
(10-0);
Timer
Activation/Regulation of Timer function for the
extractor fan
• Select the extractor fan (speed 0).
• Press (8) to access the Timer function (from
any speed)
• Regulate the duration of the Timer:
press the selector , to increase the automatic shut-
down time
press the selector , to decrease the automatic
shut-down time
the display (15) will show the countdown,
Note: on the side of the display of the extractor fan, with the
Timer in use, the following symbol will appear (19)
When the timer has finished the countdown, there is an
acoustic signal (for 2 minutes, or it will stop when one of the
buttons on the hob is pressed), while the display (15) will
flash, with the symbol “ . ".
To switch off the Timer:
• select the cooking zone
• set the value of the timer to " " , by means of
Not: the function remains active if no other key is pressed
in the meantime.
Filter saturation indicator
The hood indicates when filter maintenance is needed:
Grease filter
the “ ”(17) LED lights up
Activated carbon odour filter
the “ ”(17) LED flashes
Reset filter saturation
After carrying out maintenance on the filters (grease and/or
activated carbon) hold down the key (7);
the “ ” (17) LED turns off and the count restarts.
Activation of activated carbon odour filter saturation
indicator
This indicator is normally deactivated.
To activate it, proceed as follows:
- turn on the aspiration hob by pressing ;
- with the aspiration motor and cooking zones off, press and
hold (7);
- “ ” turns on, then off to indicate successful
activation.
Deactivation of activated carbon odour filter saturation
indicator
repeat the activation steps described above
“ ” flashes, then turns off to indicate successful
deactivation.
Automatic operation (Hob2Hood)
The hood will turn on at the most suitable speed, adapting the
extraction capacity to the cooking level used in the cooking
zone.
Once the hob is turned off, the hood adapts its aspiration
speed, gradually decreasing it, so as to eliminate residual
vapours and odours
To activate this function:
Briefly press (7) , the LED “ ” (18) will light up to
indicate that the hood is working in this mode.
Loading ...
Loading ...
Loading ...