Loading ...
Loading ...
Loading ...
PERIODIC MAINTENANCE AND ADJUSTMENT
7-35
7
EAU24361
Front wheel
EAU60841
To remove the front wheel
WARNING
EWA10822
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Place the motorcycle on the cen-
terstand.
2. Remove the axle nut.
3. Pull the wheel axle out, and then
remove the wheel. NOTICE: Do
not apply the brake after the
wheel and brake disc have been
removed, otherwise the brake
pads will be forced shut.
[ECA11073]
To install the front wheel
1. Lift the wheel up between the fork
legs.
2. Insert the wheel axle, and then in-
stall the axle nut.
3. Take the motorcycle off the cen-
terstand so that the front wheel is
on the ground.
4. Tighten the axle nut to the speci-
fied torque.
TIP
When tightening the axle nut, hold the
wheel axle with a wrench to keep it
from turning.
5. While applying the front brake,
push down hard on the handle-
bars several times to check if the
front fork compresses and re-
bounds smoothly.
EAU25081
Rear wheel
EAU66621
To remove the rear wheel
WARNING
EWA10822
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the locknut and drive
chain slack adjusting nut on each
side of the swingarm.
2. Loosen the axle nut and the brake
caliper bracket bolt.
1. Axle nut
1
Tightening torque:
Axle nut:
40 Nm (4.0 m·kgf, 29 ft·lbf)
1. Locknut
2. Drive chain slack adjusting nut
3. Axle nut
3
2
2
1
1
UB15E1E0.book Page 35 Tuesday, July 18, 2017 10:42 AM
Loading ...
Loading ...
Loading ...