Loading ...
Loading ...
Loading ...
13 141-800-798-7398 sharkclean.com
CLEANING THE MOTORIZED FLOOR
NOZZLE
When your motorized floor nozzle needs
cleaning or locks onto an object, it
automatically shuts down to prevent damage
to your lifetime belt. The indicator light will
illuminate red, warning you to turn off the
vacuum and clear blockage immediately. The
light will reset itself once blockage has been
cleared and power has been cycled on/off,
or vacuum has been locked in the upright
position.
1 Detach the motorized floor nozzle from the
portable Lift-Away
®
pod.
2 Inspect the opening underneath and the
brushroll. If a buildup of debris is present,
remove it. Use scissors to carefully cut
away anything wound around the brushroll.
CLEANING THE AIR-DRIVEN PET
BRUSH
1 Slide the locking latch forward and gently
tilt brush housing upward to remove.
2 Carefully remove any blockage or debris
and use scissors to cut away any buildup
of hair or string around the rotating bristle
brush.
3 To reassemble, insert the tabs on the front
edge of the bottom cover into the matching
holes in the top half and tilt it back down
until it clicks into place.
MAINTENANCE - cont’d
CLEANING THE POST-MOTOR HEPA FILTER
1 Remove the filter cover from the front of the vacuum by
pulling up on the tab and pulling the cover away from the
vacuum. Take out the HEPA filter by pulling it straight out.
2 Turn the filter over so that the dirty side is on the bottom
and vigorously tap it clean against a garbage can to
remove any dust.
3 Hold the filter under the tap with the dirty side facing down.
Rinse with lukewarm water until the water runs clear. Allow
filter to air-dry for 24 hours.
4 Once the HEPA filter is dry, replace it back into the vacuum.
5 Replace the cover by inserting the two tabs into the holes
at the top and then swinging the cover down until it clicks
into place.
WARNING: To reduce
the risk of shock and
unintended operation, turn
off power and unplug unit
before servicing.
NOTE: DO NOT use soap
when cleaning the filters.
Hand wash filters only with
water to prevent damage
from cleaning chemicals.
Allow ALL filters to air-dry
completely before replacing
them in the vacuum to prevent
liquid from being drawn into
electricparts. DO NOT use
a hair dryer or other heating
methods to dry.
STEP 1
STEP 2 STEP 3
Loading ...
Loading ...
Loading ...