Loading ...
Loading ...
Loading ...
11 121-800-798-7398 sharkclean.com
1 Convert your vacuum
back to upright vac mode.
2 Rotate the upper cord
hook to its upright position
and coil the power cord
loosely around the upper
and lower cord hooks.
Clip the plug onto the cord
to secure.
3 Store the dusting brush
and the crevice tool on the
mounts on the accessory
holder.
4 Store your vacuum
cleaner safely in a cool,
dry area where it will not
be a hazard, will not get
damaged, and will not
cause damage to anyone
or anything.
STORAGE AND MAINTENANCE
WARNING: To reduce
the risk of shock and
unintended operation, turn
off power and unplug unit
before servicing.
NOTE: DO NOT use soap
when cleaning the filters.
Hand wash filters only with
water to prevent damage
from cleaning chemicals.
Allow ALL filters to air-dry
completely before replacing
them in the vacuum to prevent
liquid from being drawn into
electricparts. DO NOT use
a hair dryer or other heating
methods to dry.
CLEANING THE PRE-MOTOR FILTERS
1 Remove the dust cup.
2 Pull the 2 filters out from the top of the
motor base.
3 Rinse the filters thoroughly in lukewarm
water until the water runs clear.
4 Squeeze out excess water and let air-dry
for at least 24 hours before replacing.
5 Place the felt filter in first, then the foam
filter.
6 Replace the dust cup.
NOTE: DO NOT put the filter in the washing
machine or dishwasher.
NOTE: The material in the filter will discolor
over time. This is normal, and will not affect
the performance of the filter.
EMPTYING THE DUST CUP
The dust cup needs to be emptied each time
you vacuum and periodically during cleaning,
when the dust cup appears full.
1 Undo the latches on the sides of the dust
cup by lifting them up and outwards to
remove the dust cup from the motor base.
2 Hold the dust cup over a trash receptacle
and press the bottom-door release button.
Tap gently to empty contents. Press the
door shut again until it clicks.
3 If needed, turn the dust cup upside down
over the trash receptacle and press the
top-door release button. Tap gently to
remove contents.
Use a dry cloth or paper towel to remove
debris stuck to the screen filter inside the
dust cup. Press the door shut again until it
clicks.
4 Replace the dust cup on top of the motor
base. Hook the two latches onto the tabs
on the sides of the dust cup and push
down to lock.
Pre-Motor
Foam Filter
Felt Filter
Post Motor
HEPA Filter
RECOMMENDED
CLEANING SCHEDULE:
Dust Cup
Empty after each time
you vacuum.
Pre-Motor Filter Kit
XFF350 (Foam & Felt)
Clean every 3 months.
Post-Motor Filter
XHF350 (HEPA)
Clean every 2 years.
STEP 1 STEP 2 STEP 3
Loading ...
Loading ...
Loading ...