Loading ...
Loading ...
Loading ...
- 6 -
STEP 2
A. Insert the Guide Rods (11) to the Stabilizers (1) (Note: Insert and push it to the bottom for
easy assembling), and then insert the Rubber Bumpers (26), Weight Stacks (29) & the
Selector Rod Joint (10) to the Guide Rods (11), finally fix the top end of Guide Rods (11) to
the Upright Frames (2) with E-shaped washers (40) as shown.
B. Sleeve the Wire end of Weight Stack Pin (28) to the U-shaped Pulley Block (6), then insert
the Weight Stack Pin (28) to the hole of the Weight Stack (29) & Selector Rod (10)
accordingly, finally thread the U-shaped Pulley Block (6) into the Selector Rod (10).
Loading ...
Loading ...