Loading ...
Loading ...
Loading ...
12) ADJUSTING THE HEAT OR COOL
TEMPERATURE PROGRAM
• Each period ends at the start time of the next
upcoming period.
NOTE: If configured to use only 2 periods, only DAY
and NIGHT will be used, and the MORN and EVEN
periods will not be used or visible. If you use 1
period and 7 day programming, then thermostat
will reset to the desired set temperature at the same
time each day.
• Upon entering either HEAT or COOL programming
sections, choose which day[s] you would like to
adjust with the same settings (i.e. all weekdays
together, or each day separately). Use the Up/Down
buttons to scroll through the blinking days and
press the Menu button to select each day with an
underline. Once all desired days are selected, move
blinking selection to PROG? and press the Menu
button to proceed.
• Adjust the start time of the first program period
using Up/Down buttons and press the Menu button
to advance. Adjust the start time of the first program
period using Up/Down buttons and press the Menu
button to advance.
• Use this same step-by-step process to adjust the
remaining periods for the day or group of days being
adjusted.
• When all periods have been adjusted, the screen will
blink EXIT? If you are not yet done with adjusting
other days, you can use Up/Down to select other
days with an underline just like above and repeat
the same process. If you are done, press the Menu
button to exit the programming menu. These
steps performed apply only to the mode you have
just programmed. If necessary, please repeat
programming process for alternative mode.
• If you are all done performing setting changes, move
the underline to EXIT? and press the Menu button to
return to the main home screen.
4-Periods 2-Periods 1-Period
MORN Time
HEAT
COOL
6:00 AM
70F
78F
DAY Time
HEAT
COOL
8:00 AM
62F
82F
8:00 AM
70F
74F
10:00 AM
70F
74F
EVEN Time
HEAT
COOL
6:00 PM
70F
78F
NIGHT Time
HEAT
COOL
10:00 PM
62F
75F
6:00 PM
62F
82F
13) ENTERING EMERGENCY HEAT MODE
(HP UNITS ONLY)
• While in regular HEAT mode, press and hold BOTH
the Mode and Fan buttons for at least 5 seconds,
until the screen changes. The thermostat will show
HEAT with “E” to confirm Emergency Heat mode.
This will use only the W2 wire terminal as the heating
source and will not call for compressor heating.
• To return to normal heating mode, press and
hold BOTH the Mode and Fan buttons for at least
5 seconds until the screen changes. The “E” will
disappear and only show “HEAT” to confirm regular
Heat mode.
14) SETTING A KEYPAD / FRONT PANEL LOCKOUT
• While in any normal operating mode except OFF, a
keypad lockout can be introduced which will prevent
any mode change, fan change or temperature
adjustment from being made by the user. Even when
locked, any button press will illuminate the display
backlight.
• To activate (and deactivate) the keypad lockout,
press and hold BOTH the MODE and FAN buttons
for at least 5 seconds. When the keypad is locked,
a padlock will appear in the lower le corner of the
display.
53609-17