Loading ...
Loading ...
Loading ...
8
(20) “TECHNICIAN SET UP: USE UP AND DOWN FOR SURRENT SELECTION AND NEXT STEP PREVIOUS
STEP KEY TO THE NEXT PREVIOUS STEP” displays to help technician how to operate in configuration mode
(21) Indicate current status of the thermostat
(22) “Chg Filter” displays indicate changing filter count back has expired
(23) “Comp Dly” displays when compressor delay lock out activate
(24) “Chg UV” displays when changing UV duration days has expired
INSTALLATION
1. Pull the thermostat body off the thermostat base. Forcing or prying on the thermostat will cause damage to the
unit.
2. Place base over hole in wall and mark mounting hole locations on wall using base as a template
3. Move base out of the way. Drill mounting holes. If you are using existing mounting holes and the holes drilled
are too large and do not allow you to tighten base snugly, use plastic screw anchors to secure the base.
4. Fasten base snugly to wall using mounting holes shown in Figure 3 and two mounting screws. Leveling is for
appearance only and will not affect thermostat operation.
5. Connect wires to terminal block on base using appropriate wiring schematic (See Figure 5、Figure 6)
6. Carefully line the thermostat up with the base and snap into place.
Battery Location
Batteries are optional (to provide backup power) if your thermostat was wired to run on AC power when installed.
Loading ...
Loading ...
Loading ...