Loading ...
Loading ...
Loading ...
wolfappliance.com
|
7
Troubleshooting
IMPORTANT NOTE: If the vacuum seal drawer does not
operate properly, follow these troubleshooting steps:
• Verify electrical power is supplied to the unit.
• Verify proper electrical connections.
• If the vacuum seal drawer does not operate properly,
contact Wolf Factory Certied Service. Do not attempt
to repair the vacuum seal drawer. Wolf is not responsible
for service required to correct a faulty installation.
Preparation
Remove and recycle packing materials. Do not discard the
package containing two screws provided for installation.
Install an anti-tip block against the rear cabinet wall. Verify
screws are adequately secured and do not penetrate elec-
trical wiring or plumbing.
Installation
1 Turn off power to the electrical outlet.
2 Place the unit on a protected work surface and remove
the two shipping screws from the back of the unit. Refer
to the illustration below.
3 Place the unit near the opening and plug the power cord
into the receptacle.
4 Slide the unit into the opening.
5 Open the drawer to full extension.
6 Drill a pilot holes in each mounting hole location. Refer
to the illustration below.
7 Secure the unit with the screws provided.
8 Turn on the electrical supply to the outlet and verify
operation.
INSTALLATION
SHIPPING
SCREWS
MOUNTING
HOLE
Shipping screw location
Mounting hole location
Sub-Zero, Sub-Zero & Design, Sub-Zero & Snowake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf &
Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design are registered trademarks and service marks of Sub-Zero Group, Inc. and its subsidiaries.
All other trademarks are property of their respective owners in the United States and other countries.
Loading ...
Loading ...
Loading ...