Loading ...
Loading ...
Loading ...
ENGLISH
10
2 Make sure there is enough water (more than 3/4) in the water tank. If there is not
enough water, unplug the iron, ll the water to MAX indication (Fig.3-2) and plug in
the iron again (Fig.3-3).
Do not pour vinegar or other descaling agents into the water tank.
3 Wait for the iron to heat up. This takes about 2 minutes (Fig.3-3).
Note: the Calc-Clean reminder light turns o during heating up.
4 Unplug the iron when the ‘iron ready’ light stops breathing (Fig. 3-4).
5 Hold the iron over the sink. Keep pushing the Calc-Clean button and gently shake
the iron forth and back until all water in the water tank has been used up (Fig. 3-5).
Scales is ushed out, steam and boiling water also come out of the soleplate.
Note: Repeat steps 2 to 5 if the water that comes out of the appliance still contains
scale particles.
6 Plug in the appliance and let the appliance heat up to dry the soleplate. This takes
about 2 minutes (Fig.3-6).
7 Unplug the appliance. Move the appliance gently over a piece of cloth to remove any
water stains on the soleplate (Fig. 3-7).
Troubleshooting
This chapter summarises the most common problems you could encounter with the
appliance. If you
are unable to solve the problem with the information below, visit
www.philips.com/support
for a list of frequently asked questions or contact the
Consumer Care Centre in your country.
Problem Possible cause Solution
The iron does
not produce any
steam.
There is not enough water
in the tank.
Fill the water tank.
The steam setting is set to
“steam o”
Tilt the iron up and press the steam button on
top of the handle to select a steam setting.
The iron is not ready. Wait until the iron is ready (the light on the
display panel stops ashing).
The steam setting
does not change
when I press the
steam button on
top of the handle.
The steam button changes
steam settings only
when the iron is tilted. In
horizontal position, the
steam button serves as
a trigger to release extra
steam in any setting.
Tilt the iron up slightly and press the steam
button to change steam setting.
This is designed to ensure the consumers do
not accidentally change the steam setting
while ironing.
The ironing board
cover becomes
wet or there are
water droplets on
the garment during
ironing.
Steam has condensed on
the ironing board cover
after a long ironing session.
Replace the ironing board cover if the foam
material has worn out. You can also add an
extra layer of felt material under the ironing
board cover to prevent condensation on the
ironing board. You can buy felt in a fabric shop.
Loading ...
Loading ...
Loading ...