Loading ...
Loading ...
Loading ...
11
LED indicator status of the receiver
Power
LED
Status
LED
Mode and status
Solid
red
Off Standby mode for power-
saving
Flashing
blue
Flashing Setting up a Link between
the transmitter and
receiver
Solid
blue
Flashing
quickly
On mode but without
input from the computer/
source device
Solid
blue
Flashing
slowly
On mode with
unrecognized video format
Solid
blue
Solid
blue
On mode with recognized
video format
Note
•
If the link is not established after 80 seconds, move the
transmitter, receiver and HDTV closer to each other.
The maximum transmission range is up to 23 feet
(7 meters).
• If more than one set of Philips Wireless HD Net
Connect is placed in the same room, make sure that
the minimum distance among each one is 6 feet
(2 meters).
• Make sure the computer is on and the video output on
• the laptop/PC is switched to HDMI.
• Make sure the video format is supported before the
video is displayed, see the chapter on Technical data for
information.
• If the picture on your TV is not full screen, see the
chapter on ‘Frequently asked questions’ for information..
Establish the link between the
transmitter and receiver
• A ashing blue power LED is displayed
until the signal link between the two units
is established. Normally, it takes around
15-20 seconds for the link to establish
successfully.
• When you unplug the power cord of the
transmitter, the receiver enters standby
mode after 5 minutes.
» The power LED of the receiver lights
up in red.
• The link between the transmitter and
receiver is re-established when you plug in
the power cord of the transmitter again.
» The power LED of the receiver ashes
in blue.
LED indicator status of the
transmitter
Power LED indicator Status
Solid blue The link is established.
Flashing blue Linking is in progress.
EN
English
Loading ...
Loading ...
Loading ...