Loading ...
Loading ...
Loading ...
24
PAGE HEAdER.....
25
PAGE HEAdER.....
CARE & CLEANING
CLEANING tHE StEAM WANd ANd FRotHING AttACHMENt
• The steam wand and frothing
attachment should always be cleaned
after texturing milk.
• Remove the frothing attachment and
rinse in warm tap water.
• Wipe the steam wand with a damp cloth,
and then with the steam wand directed
back into the drip tray, briefly set the
steam dial to the STEAM position. This
will clear any remaining milk from
inside the steam wand.
• Ensure the steam dial is in the STANDBy
position. Press the POWER button to Off
and allow the machine to cool.
• If the steam wand remains blocked,
use the pin on the cleaning tool to clear
the opening.
• If the steam wand continues to be
blocked, the tip of the steam wand can
be removed by using the spanner in the
middle of the cleaning tool.
• Unscrew the tip with the cleaning tool.
• Soak the tip in hot water before using
the pin on the cleaning tool to unblock.
Replace the tip back onto the steam
wand and secure with the cleaning tool.
Wipe steam wand after
each use
Clean hole with pin Remove tip Soak tip overnight then
re-attach
Run steam to clear milk
from wand after texturing
1 2 3 4 5
CARE & CLEANING
Concentrated Solution (for harder water)
• 1 part white vinegar
• 1 part cold tap water
WARNING
Do not immerse power cord, power
plug or appliance in water or any other
liquid. The water tank should never be
removed or completely emptied during
decalcifying.
dECALCIFyING tHE MACHINE
• Remove the portafilter and frothing
attachment. Pour the mixture of white
vinegar and water into the water tank.
• Plug the machine into the power outlet
and switch On.
• Press the POWER button to the On
position.
• Place a large container under the group
head and steam wand.
• When the brewing temperature has been
reached all the button surrounds on
the control panel will illuminate. Press
and hold the 1 CUP or 2 CUP button to
commence manual pour. Release the
button once half the mixture of white
vinegar and water has run through the
group head.
• Set the STEAM/HOT WATER dial to
the STEAM position and allow steam
to run through the Steam Wand for
approximately 2 minutes. Return the
steam dial back to the STANDBy position.
• After decalcifying, remove the water
tank and rinse thoroughly then refill
with fresh cold water. To rinse the
machine, repeat previous steps.
Loading ...
Loading ...
Loading ...