Loading ...
Loading ...
Loading ...
5
STANDARD OR ANGLE MOUNT INSTRUCTIONS
1. Feed the fan wires through the yoke cover, canopy and downrod (Figure 3.1).
2. Slide the downrod into the yoke of the motor assembly. Align holes and reinstall the downrod pin and downrod clip and secure
with the two set screws (Figure 3.2).
3. Depending on the length of downrod you use, you may want to trim the fan wires to simplify wiring. After pulling the wires all
the way through the downrod, measure 8 inches of wire. Cut off the excess wire using wire cutters (not included). Then strip
1/2 inch of insulation from the end of each wire strand (Figure 3.3).
4. Install the ball end of the downrod into the opening of the mounting bracket (Figure 3.4). WARNING: Failure to align the slot
in the ball with the tap on the mounting bracket may cause the fan to fall, which could result in injury or death.
5. Insert the receiver into the mounting bracket with the at side facing the ceiling (Figure 3.5).
Skip to FINAL INSTALLATION, page 6.
Figure 3.1
Figure 3.4 Figure 3.5
Downrod Clip
Set Screw
Downrod
Downrod Pin
Downrod
Canopy
Yoke Cover
Figure 3.2 Figure 3.3
8 in.
Receiver
Mounting
Bracket
Mounting
Bracket
Downrod
Tab
Slot
Loading ...
Loading ...
Loading ...