Loading ...
Loading ...
Loading ...
Basic Operations
36
Tips
• To select a programme position, you can use the programme number buttons on
the remote commander. For two-digit numbers, press the ? (ten’s digit) button
followed by the programme number buttons.
• You can select a video source from the LINE-1 (TV) or LINE-3 IN connector, or
LINE-2 IN jacks using INPUT SELECT or PROG +/–. When you use PROG +/–,
“L1,” “L3” or “L2” appears in the display window between the lowest programme
position and the highest one.
• The display appears on the TV screen indicating information about the tape, but the
information won’t be recorded on the tape.
• If you don’t want to watch TV while recording, you can turn off the TV.
Notes
• The display does not appear during still (pause) mode or slow-motion playback.
• The display will not appear while playing an NTSC-recorded tape.
• If a tape has portions recorded in both PAL and NTSC systems, the time counter
reading will not be correct. This discrepancy is due to the difference between the
counting cycles of the two video systems.
• When you insert a non-standard commercially available tape, the remaining time
may not be correct.
• The remaining time doesn’t work for an NTSC-recorded tape. “–:– –” appears in the
display window.
• The remaining time is intended for rough measurement only.
• If you play back the tape for about 30 seconds after you have inserted it, the
remaining time will be displayed.
Recording TV programmes (continued)
Loading ...
Loading ...
Loading ...