Loading ...
Loading ...
Loading ...
(228,1)
北米Model "A2550BE-B" EDITED: 2019/ 1/ 16
vary by brand of garage door opener. If it is
difficult to locate the training button, refer
to your garage door opener’s instruction
manual.
1) Training button
2. Press the training button on the garage
door opener motor head unit (which
activates the “training light” on the unit).
Proceed to step 3 within 30 seconds.
3. Inside the vehicle, firmly press, hold for
2 seconds and release the HomeLink
®
button that was programmed in the pre-
vious section. Press and release the
button a second time to complete the
programming procedure.
NOTE
Some garage door openers may require
you to do the above press-hold-release
sequence a third time to complete the
programming.
4. The garage door opener should now
recognize the HomeLink
®
Wireless Control
System and your garage door opener
should activate when the HomeLink
®
button is pressed.
! Programming for entrance gates
and garage door openers in
Canada
S03AP090403
1. Unplug the motor of the entrance gate
or garage door opener from the outlet.
NOTE
If any of the HomeLink
®
buttons are
already programmed for other devices,
skip step 2 because it clears the
memory of all three buttons.
1) HomeLink
®
button 1
2) HomeLink
®
button 2
3) HomeLink
®
button 3
2. Press and hold the two outer
HomeLink
®
buttons (button 1 and button
3) until the HomeLink
®
indicator light
begins to flash (after approximately 10
seconds). Then release both buttons.
3. Hold the end of the entrance gate’s/
garage door opener’s hand-held transmit-
ter between 1 and 3 inches (25 and 76
mm) away from the HomeLink
®
button you
wish to program.
4. Press and hold the desired HomeLink
®
button.
5. Press and release (“cycle”) the hand-
held transmitter button every 2 seconds
until step 6 is complete.
Instruments and controls/Mirrors
3-70
Loading ...
Loading ...
Loading ...