Loading ...
Loading ...
Loading ...
25
PROBLEM POSSIBLE CAUSE SOLUTION
Then handle is not The bolts are not properly Make sure the bolts are correctly installed
in position. seated. through the handle bars. Check to see if
the hand knobs are tight.
Refer to Assembling the Handle section in
this manual.
The Snow Thrower The switch is defective. Have the switch replaced by an authorized
does not start. service center.
The extension cord is not Connect the plug on the snow thrower to
connected to the plug. the extension cord.
The extension cord is not Plug the extension cord into a live 120 V
connected to the power source. AC, 60 Hz outlet.
The motor is on, but The belt is damaged. Replace the belt (see the section entitled
the impeller does Inspecting/Replacing the Drive Belt).
not turn.
The snow thrower The scraper is worn. Inspect the scraper for wear or damage.
leaves a thin layer of Replace the scraper (see the section
snow behind. entitled Replacing the Scraper).
TROUBLESHOOTING
Loading ...
Loading ...
Loading ...