Loading ...
Loading ...
Loading ...
EFX5.19 Elliptical Fitness Trainer Assembly Guide 5
Assembly Steps
Connect the display console cable, and then cut the
tie wrap holding the cable to the upright support.
CAUTION: Avoid dropping the cable inside the
upright support. Use extreme care when cutting
the tie wrap. Cut or damaged cable is not
covered by the Precor Limited Warranty.
Push excess cable into the upright support, and then
secure the display console to the upright support
using four Phillips-head screws (G). Wrench tighten.
Thread the display cable through the
grommet and out the front of the base
tube. Plug the cable connector into its
receptacle.
Important: If the plastic grommet pops
out of the base, replace it immediately.
The grommet covers the metal edges so
the cables are not cut or damaged.
Align the mounting holes and secure the upright support to
the base using one hex head bolt (A), two washers (B), and
one locknut (C). Finger tighten.
Push excess cable into the base tube.
CAUTION: Be aware of a sharp screw inside the
base tube. Abrasive cuts or other injuries can
occur if you place your hands, fingers, bare feet, or
toes inside the base tube.
Install the link arm caps using
two Phillips-head screws (H).
Wrench tighten.
Lift the EFX, and then slide a wedge of
packing material under the front of the unit.
Loading ...
Loading ...
Loading ...