Loading ...
Loading ...
Loading ...
TEC_TM_009 | REV. I | EN 03/21/2023 Page 17 of 76
TR-30/36 INSTALL MANUAL
PAGE TITLE
ELECTRICAL AREA
WATER AREA
SITE PREPARATION
FIG. 1.
Water line connection. Fitting included, PEX not included
Plumbing Requirements
Water Supply
1/4" PEX tubing (1/4" O.D. lines
and fittings not included
NOTE: Copper line is not
recommended
Flow Rate 0.5 gpm / 1.89 lpm
Operating Pressure 30-100 psi (207-689 kPa)
Incoming Water Temperature 33-10 0°F (0.6-38°C)
NOTE: DIMENSIONS MAY VARY BY ± 1/8” (3.175 mm)
OPTIONAL ICEMAKER REQUIREMENTS
(TR-30FRZ/36FRZ-IM-C)
WATER SUPPLY REQUIREMENTS
WARNING! Only connect to a potable
water supply!
AVERTISSMENT! Raccorder uniquement à
une source d'eau potable!
Units with optional ice makers come with 20” (508
mm) of polyethylene tubing with a 1/4” O.D. push
connector for customer attachment.
Before installing your unit, prepare the water supply
line. Please see plumbing requirements in the
plumbing requirements table.
• Purge the water line prior to final connection to the
unit. This removes any debris present in the line.
• Only connect to a potable water supply!
• Do not connect to a hot water supply!
• Install the water filter before turning on the
water supply to the icemaker. See “Water Filter
Installation” (page 18).
• A copper line is not recommended for this
application.
• Check all water line fittings for leaks.
• Tape the supply line to the floor before moving the
unit into its final installation location.
• In the water connection area (see the rough opening
illustration), tape the water line to the floor.
Loading ...
Loading ...
Loading ...