Loading ...
Loading ...
Loading ...
76
reassembling the sprayhead
/
seal
If Sprayhead and seal are separated during removal or cleaning, they must be
reassembled properly.
cleaning the sprayhead
Mineral deposits and loose coffee or tea granules may clog the Sprayhead, causing the brew
cycle to slow.
1. Open Spin Lid on top of brewer.
2. Fill Pour-in Bowl with 14 oz. white vinegar.
3. Close Spin Lid.
4. Place empty cup (greater than 14 oz.) on
the Travel Mug Base or Drip Tray Cover.
5. Push Brew Button to cycle vinegar through
brewer.
6. Run at least two additional 14 oz. cycles of
water through brewer to flush remaining
vinegar from brewer.
7. Follow the steps below to clean the
Sprayhead.
1. Unplug the brewer and allow it to cool
(minimum 1 hour).
2. Remove Pod Drawer.
3. Using your fingers, rotate the Sprayhead
assembly clockwise until the Sprayhead
and seal are removed.
4. Clean Sprayhead and seal with mild
detergent and rinse thoroughly. A
toothpick may also be used to clear
debris from Sprayhead holes.
CAUTION: If the Sprayhead and seal are
separated, they must be reassembled.
Improper reassembly could result in injury
from scalding water
5. With your fingers, rotate Sprayhead
counter-clockwise until finger tight.
6. Replace Pod Drawer.
7. Plug in brewer to restore power.
1. Identify the top of the seal – it will have
rough ridges and the bottom is smooth
2. Identify the top of the Sprayhead – it has
a star pattern and a threaded hole where
the Sprayhead attaches to the brewer.
3. While carefully stretching the seal, guide
the Sprayhead into the channel of the seal.
Make sure it is completely in the channel.
When properly assembled, the Sprayhead
will slide easily into the channel of the
seal and will not cause any buckles in the
surface of the seal.
CAUTION: Improper reassembly could
result in personal injury from hot water.
CLEANING & MAINTENANCE
CLEANING & MAINTENANCE
basic cleaning
Rinse the Pod Drawer after each use – especially when switching between coffee and
tea pods. Pod Drawer, Drip Tray and Drip Tray Cover are top rack dishwasher safe.
Occasionally wipe outside of the brewer, including the Drip Tray and Drip Tray Cover,
with a mild, no citrus added dish soap and a damp cloth.
deep cleaning
Deep clean your brewer at least every 3 months. Mineral deposits may accumulate due
to impurities in the water used to brew. If deposits are not removed, they can impair the
operation of the brewer and reduce product life. The frequency of cleaning depends on the
mineral content of your water (the higher the mineral content, the more often you should
deep clean).
inspecting the sprayhead seal
When disassembling your brewer for cleaning, inspect the Sprayhead seal for cracks, tears
and holes. Although the seal should last for an extended period of time, damage can occur
through handling.
CAUTION: The seal confines hot liquid to the Pod Drawer. If damaged, call Customer
Service at 800-352-2866 or visit www.bunn.com to obtain a replacement seal.
storing the brewer
Unplug the brewer and wait for it to cool. It must be stored above 32°F/0°C to prevent
damage to the internal water tank. If you do not use your brewer for an extended period of
time, we recommend running two to three cycles of water through prior to brewing coffee
or tea.
Loading ...
Loading ...