Loading ...
Loading ...
Loading ...
12 INSTALLATION
Installing the Charging
Station
WARNING
To prevent tipping, self-standing mode
installations should be anchored to the wall
using the provided stand anchoring screw,
anchoring block and double-sided tape.
CAUTION
Do not allow children or pets to hang onto the
charging station. They could be injured or cause
damage to the appliance.
Take care not to drop the product parts while
unpacking them to avoid appliance damage or
personal injury.
Do not use double-sided tape to attach the
charging station to wallpaper. The weight of the
charging station and the product body could
damage the paper.
Use the stand anchoring screw on concrete or
solid walls. If the appliance is not anchored
securely and falls, it could result in damage to
property or the product.
NOTE
Once assembled, the floor stand dock and the
floor stand pipe cannot be disassembled.
The cost of a service call to install or reinstall the
charging station is not covered under the
warranty.
Wall-Mounted Installation
For wall-mounted installations, the charging
station must be attached securely to the wall using
the provided (short) wall anchoring screws.
The detachable nozzle storage cannot be
attached to the charging station in a wall-
mounted installation.
1 Connect the power adapter to the port on the
back of the charging station.
2 Drill 2 holes and insert the drywall anchors (if
needed) at least 3.25 ft (1 m) from the floor
and near enough to easily reach a power
outlet.
Before drilling, make sure that there are no
pipes or electrical wires inside the wall at
the desired location.
For drywall anchor: use 1/4 (6.5 mm) drill
bit
For concrete or wall stud: use 1/8 (3 mm)
drill bit
If screwing into drywall, use the drywall
anchors.
3 Attach the charging station to the wall with
the wall anchoring screws.
4 Plug the power cord into the power outlet.
Self-Standing Installation
Follow the steps below to install the charging
station on a hard and level floor.
3.25 ft
us_main.book.book Page 12 Tuesday, March 16, 2021 10:31 AM
Loading ...
Loading ...
Loading ...