Loading ...
Loading ...
Loading ...
Features of your vehicle
364
✽✽
NOTICE
Some devices may require you to replace
this Programming step 3 with procedures
noted in the "Gate Operator/Canadian
Programming" section. If the
HomeLink
®
indicator light does not
change to a rapidly blinking light after
performing these steps, contact
HomeLink
®
at www.homelink.com.
4.Firmly press, hold for 5 seconds and
release the programmed HomeLink
®
button up to two separate times to acti-
vate the door. If the door does not acti-
vate, press and hold the just-trained
HomeLink
®
button and observe the
indicator light.
• If the indicator light stays on con-
stantly, programming is complete and
your device should activate when the
HomeLink
®
button is pressed and
released.
• If the indicator light blinks rapidly for 2
seconds and then turns to a constant
light, continue with "Programming"
steps 5-7 to complete the program-
ming of a rolling code equipped
device (most commonly a garage
door opener).
5.At the garage door opener receiver
(motor-head unit) in the garage, locate
the "leam" or "smart" button. This can
usually be found where the hanging
antenna wire is attached to the motor-
head unit.
6.Firmly press and release the "leam" or
"smart" button.(The name and color of
the button vary by manufacturer).
There are 30 seconds to initiate step 7.
7.Return to the vehicle and firmly press,
hold for 2 seconds and release the pro-
grammed HomeLink
®
button. Repeat
the "press/hold/release" sequence a
second time, and, depending on the
brand of the garage door opener (or
other rolling code equipped device),
repeat this sequence a third time to
complete the programming process.
HomeLink
®
should now activate your
rolling code equipped device.
Loading ...
Loading ...
Loading ...