Loading ...
Loading ...
Loading ...
10 English
STEP 6:
Disconnect the garden hose from the water
inlet on the unit.
STEP 7:
Disconnect the high pressure hose from the
high pressure outlet. Store the high pressure
hose in the gun holder assembly.
STEP 1:
If detergents have been used, remove deter-
gent suction tube from container and insert into
1 gallon of fresh water.
Siphon water at low pressure for one minute
to clear the line of residual detergent.
STEP 2:
Move the engine stop switch to the OFF posi-
tion. Close the fuel valve.
STEP 3:
Turn off the water source.
STEP 4:
Press trigger to release water pressure.
STEP 5:
Release trigger and engage gun safety lock.
SHUTTING DOWN & CLEAN-UP
Initial Use
All Kärcher pumps ship with oil already inside direct
from the factory.
Pump Inspection
You should routinely make a visual inspection of the
pressure washer’s pump. If you notice oil leaking
around the pump seals, you should take the pressure
washer to a Kärcher-Authorized Service Center for
repair. (You can locate a service center in your area
online at: www.karcher-service.com).
Pump Maintenance
Change oil after first 50 hours of operation and then
every 200 hours or 3 months, wichever occurs first.
When changing pump oil use only high quality non-
detergent 30 weight oil. Use no special additives.
Carry out maintenance tasks for the engine accord-
ing to the specifications provided in the operating
instructions provided by engine manufacturer.
Kärcher pump
Engine
MAINTENANCE INSTRUCTIONS
WINTERIZING AND LONG-TERM STORAGE
STEP 6:
Screw bottle into water inlet on pressure
washer pump and squeeze.
CAUTION
Failure to follow the above directions may
result in damage to the pump assembly and
accessories and void the warranty.
It is highly recommended to use Kärcher's
Pump Guard (part number 9.558-998.0) before
winter storage and during the cleaning season
to protect the pump from freezing and prema-
ture wear.
STEP 1:
Turn engine switch to the OFF position
STEP 2:
Disconnect all hoses.
STEP 3:
Unscrew cap from Pump Guard bottle.
STEP 4:
Remove internal seal.
STEP 5:
Reattach cap to Pump Guard bottle and re-
move black protective cap.
STEP 7:
With ignition OFF, pull starter rope until fluid
starts to exit.
STEP 8:
Unscrew bottle. Store or dispose properly..
Loading ...
Loading ...
Loading ...