Loading ...
Loading ...
Loading ...
Maintenance - Bearing
Evaporator and Auger Inspection
The bearings and water seal should be checked
once per year.
Ice Breaker and Auger Removal for Inspection
Note: The auger can’t be pulled out when the unit
is installed under the counter.
1. Remove the hood, door and ice storage bin.
2. Remove stainless steel cover plate.
3. Remove cover from reservoir, and block the float
or shut off the water supply.
4. Locate evaporator drain and drain the
evaporator/reservoir.
5. Remove sealing cap and check the top bearing
surface for water, rust, or wear. replace it if
required.
6. Attach removal tool and lift auger from
evaporator.
7. After the auger has dried, check condition of the
auger’s finish, it should be clean and shiny. If not,
scrub with Scotsman ice machine cleaner and a
clean brush.
8. Reverse all of the above to reassemble.
AFE400
February 2009
Page 12
Electrical shock
hazard.
Electrical shock can
cause personal injury.
Disconnect power before
beginning to service
components.
Sealing Cap
Loading ...
Loading ...