Loading ...
Loading ...
Loading ...
122 STARTING AND OPERATING
Adjustable Chime Volume Settings
Rear chime volume settings can be selected
from the Uconnect system Ú page 140.
The chime volume settings include low,
medium, and high.
ParkSense will retain its last known
configuration state through ignition cycles.
PARKSENSE WARNING DISPLAY
The ParkSense Warning screen will only be
displayed if Sound and Display is selected from
within the Uconnect system Ú page 140.
The ParkSense Warning screen is located within
the instrument cluster display Ú page 75. It
provides visual warnings to indicate the
distance between the rear fascia/bumper and
the detected obstacle.
ENABLING AND DISABLING PARKSENSE
ParkSense can be enabled and
disabled with the ParkSense switch.
When the ParkSense switch is pushed
to disable the system, the instrument cluster
will display the “ParkSense Off” message for
approximately five seconds. When the gear
selector is moved to REVERSE and the system is
disabled, the instrument cluster display will
display the “ParkSense Off” message for as
long as the vehicle is in REVERSE.
The ParkSense switch LED will be on when
ParkSense is disabled or requires service. The
ParkSense switch LED will be off when the
system is enabled. If the ParkSense switch is
pushed and the system requires service, the
ParkSense switch LED will blink momentarily
and then the LED will be on.
SERVICE THE PARKSENSE PARK ASSIST
S
YSTEM
During vehicle start up, when the ParkSense
Rear Park Assist System has detected a faulted
condition, the instrument cluster display will
actuate a single chime, once per ignition cycle,
and it will display the “PARKSENSE
UNAVAILABLE WIPE REAR SENSORS” or the
“PARKSENSE UNAVAILABLE SERVICE
REQUIRED” message. When the gear selector is
moved to REVERSE and the system has
detected a faulted condition, the instrument
cluster display will show the "PARKSENSE
UNAVAILABLE WIPE REAR SENSORS" or
"PARKSENSE UNAVAILABLE SERVICE
REQUIRED" message for as long as the vehicle
is in REVERSE. Under this condition, ParkSense
will not operate.
If “PARKSENSE UNAVAILABLE WIPE REAR
SENSORS” appears in the instrument cluster
display, make sure the outer surface and the
underside of the rear fascia/bumper is clean
and clear of snow, ice, mud, dirt or other
obstruction and then cycle the ignition. If the
message continues to appear, see an
authorized dealer.
If “PARKSENSE UNAVAILABLE SERVICE
REQUIRED” appears in the instrument cluster
display, see an authorized dealer.
CLEANING THE PARKSENSE SYSTEM
Clean the ParkSense sensors with water, car
wash soap and a soft cloth. Do not use rough or
hard cloths. Do not scratch or poke the sensors.
Otherwise, you could damage the sensors.
21_LD_OM_EN_USC_t.book Page 122
Loading ...
Loading ...
Loading ...