Loading ...
Loading ...
Loading ...
13
INSTALLATION INSTRUCTIONS
1. If possible avoid placing the appliance near cookers, radiators or in direct sunlight as this will cause
the compressor to run for long periods. If installed next to a source of heat or refrigerator, maintain
the following minimum side clearances:
From Cookers 4" (100 mm)
From Radiators 12" (300 mm)
From Fridges 4" (100 mm)
2. Make sure that sufficient room is provided around the appliance to ensure free air circulation.
Ideally, A space of no less than 10cm must be left around the freezer, and ensure you allow gaps as
shown in the below diagram.
3. The appliance should be located on a smooth surface.
4. It is forbidden to use the refrigerator outdoors.
5. Protection from moisture. Do not locate the freezer in moist space to avoid the metal parts rusty.
And do not spray water to the freezer, otherwise it will weaken the insulation and causes current
leakage.
6. Refer to "Cleaning and Care" section to prepare your appliance for use.
7. If the freezer is installed in unheated areas, garages etc., in cold weather condensation may form
on the outer surfaces. This is quite normal and is not a fault. Remove the condensation by wiping
with a dry cloth.
STARTING TO USE
Before you starting to use the freezer, please check that:
1. The interior is dry and air can circulate freely at the rear.
2. Clean the interior as recommended under "TAKE CARE" section.
3. Insert the plug into the wall socket and switch on the electricity supply, then the Red light is
on. Avoid accidental disconnection by taping over the switch. Green light will glow and the
compressor will start running.
4. You will hear a noise as the compressor starts up. The liquid and gases sealed within the
refrigeration system may also give rise to noise, whether the compressor is running or not
which is quite normal.
Loading ...
Loading ...
Loading ...