Loading ...
Loading ...
Loading ...
6
IMPORTANT!
Venting directly into the cabinet with no vent is not permitted.
WARNING!
This appliance is heavy and requires two persons for unpacking and installation.
Installation work and electrical wiring must be done by qualified person(s) in
accordance with all applicable codes and standards.
Failure to install the screws or fixing device in accordance with these instructions
may result in electrical hazards
When cutting or drilling into wall or ceiling, do not damage electrical wiring
andother hidden utilities.
IMPORTANT!
Wear gloves to protect against sharp edges.
The manufacturer is not liable for any damage caused by not following these
instructions.
Before you start installation
Ensure you have read the ‘Installation preparation’ section of this guide.
Unpack the range hood.
Ensure the voltage (V) and the frequency (Hz) indicated on the serial plate match
thevoltage and frequency of the installation site.
Check all functions of the range hood are working.
Check that the area above and behind the installation surface is clear of any electrical
cables or pipes and there is proper clearance for the ducting etc.
The range hood surfaces can be damaged during installation if grazed or knocked
bytools. Please take care to protect the surfaces during installation.
Remove protective wrappings that will not be accessible after installation.
Protect the cooktop to prevent damage occurring whilst the range hood is being
installedabove.
The wall or cabinet used for mounting the range hood should have sufficient
strengthand aflat surface.
WARNING!
Installation work and electrical wiring must be done by qualified person(s) in
accordance with all applicable codes and standards.
This unit must be earthed/grounded. Improper earthing/grounding can result in
arisk of electric shock.
1
Ensure the cabinetry has the required cutout for insertion of the range hood.
Refer to the ‘Cabinetry cutout dimensions’ section of this installation book.
2
If you are using a duct adaptor this must be installed to the range hood prior to the
range hood being mounted. Please refer to ‘Duct adaptor assembly’ for details on
how to install your ductadaptor.
3
Ensure the mounting brackets are set to the correct position for installation by
checking thetop of the foot lines up with the notches (refer to C). Note: Adjusting
the mounting bracket up or down from this position prior to installation could cause
the range hood to be difficult to install and/or damage the cabinetry.
4
Lift the range hood into the opening until the spring loaded mounting brackets click
into place and support the weight of the range hood (refer D). For larger size range
hoods this will require two people. Note: Depending on the cabinetry base panel
thickness the range hood will be protruding below the cabinetry until tightened.
5
Secure the range hood into the cabinetry by tightening each of the mounting
brackets in acounterclockwise direction (refer to E). Tighten each bracket in
succession around the range hood to close the gap incrementally for each bracket.
6
Remove the junction box cover by removing the two screws (refer to F).
7
Remove the electrical knockout and install a cULus listed 1/2” (12.7mm) wiring conduit
and strain relief in the junction box.
8
Run three wires through the conduit from the power supply to the junction box.
9
Connect the power supply wires to the range hood wires using suitable cULus listed
wire nuts:
– black to black
– white to white
– green/yellow to green/yellow
!0
Close the junction box cover and secure with screws.
!1
Complete the installation
Install the filters as described in the ‘Cleaning and maintenance’ section of your
Userguide.
Remove all protective wrapping from range hood.
Turn the power on at control panel.
Check the operation of the range hood as described in the ‘Operating instructions’
section of your User guide.
Refer to G for an image of a completed installation.
5INSTALLATION INSTRUCTIONS
Loading ...
Loading ...
Loading ...