Loading ...
Loading ...
Loading ...
4
IMPORTANT
The HPB3011-4, HPB3011-6, HPB3611-4 and HPB3611-6 models are not suitable for use
witha high powered professional style cooktops.
Range hood width
The range hood width is recommended to be no less than the width of the cooktop.
A wider range hood can be used to increase the capture area if space is not restricted.
The range hood should ideally be centered above the cooktop for proper performance.
WARNING!
To reduce the risk of fire, use only metal ductwork. Do not use flexible ducting
Installation location—Ducting preparation
The range hood is suspended under the cabinetry. The ducting can be configured for
bothvertical and horizontal discharge. The ducting can terminate either through the roof
orwall, to vent through the wall a 90° elbow is needed.
Optional extras
All optional extras must be installed prior to the range hood being installed.
Remote control
If an optional remote control was purchased for installation with the range hood the
remotecontrol receiver must be assembled into the range hood prior to installation.
Installation must be undertaken by an approved service technician. Instructions for
installation are provided with the receiver.
Duct adaptor
A 8” (203mm) or 10” (254mm) round duct adaptor is supplied to mount to the top of
the range hood toprovide a single outlet. This should be installed before the range hood
ismounted.
Duct adaptor assembly
Place the duct adaptor over the range hood exhaust and secure with four 5/16”(8mm)
screws provided (refer to A).
Seal the connection between duct adaptor and range hood with aluminum tape (refer to B).
Note: Double blower models have a adaptor ring as shown below. The assembly steps are
the same as above.
Range hood height
INSTALLATION DIMENSIONS inches (mm)
A
Top of cooking surface to base
ofthe range hood
Minimum 30” (762)
Maximum recommended 42” (1067)
The installation height ranges from a minimum height
of 30”(762mm) to a maximum recommended height
of 42”(1067mm). Consult the cooktop Installation
and User guide for details of the required installation
heightof the range hood.
This range hood must be installed no lower than
the minimum height indicated in the table above.
Minimuminstallation height may be greater if required
by the cooktop manufacturer. Installation at the
minimum height will improve the efficiency of capturing
cooking odors, grease and smoke. Installation at
the maximum recommended height improves user
ergonomics by offering increased head room.
IMPORTANT
Always switch your range hood on when you
arecooking.
Using a powerful gas cooktop or multiple gas burners
operating at the same time can cause the range hood
surfaces to become hot, this effect can be reduced by:
– Using the maximum speed setting to enable hot
air to be extracted quickly.
– Installing the range hood at the maximum
recommended height. Consult the cooktop
Installation and User guide for details on the
installation height of the range hood.
Cabinet mounting installation
The cabinet must be of sufficient strength and
structurallyjoined to the wall studs to support the
weightof this range hood.
If support beams are added to cabinetry these must
notbe more than 11/2”(38mm)
B
high from the
underside of the cabinet. Beams that are higher will
prevent accessfor servicing.
The range hood must be installed into an opening on
theunderside of the cabinet.
Cabinet opening dimensions that are shown must be
used, see ‘Product and cabinetry cut-out dimensions’
section. Given dimensions provide minimum clearance.
We recommend the cupboard has a door or service panel
that can be easily opened to access the power connection.
A
B
A
B
Double blower adaptor: Single blower adaptor:
4INSTALLATION PREPARATION
Loading ...
Loading ...
Loading ...